Re: [PATCH v9 2/8] t2400: print captured git output when finished

[Junio C Hamano <gitster@pobox.com>]

Jacob Abel <jacobabel@nullpo.dev> writes:

> On 23/04/19 09:23AM, Jacob Abel wrote:
>> On 23/04/18 09:34AM, Junio C Hamano wrote:
>> > [...]
>>
>> Ah ok I understand what you mean now.
>>
>> Would the following work? Since all we care about in `git worktree add` is
>> `stderr`, can't we just duplicate `stderr` to `stdout` while redirecting
>> stderr to `actual` so that in the event the git command fails, it's still
>> displayed in the output of `sh t2400-*.sh -x`?
>>
>> diff --git a/t/t2400-worktree-add.sh b/t/t2400-worktree-add.sh
>> index 82091cbb1f..a8f734b1c3 100755
>> --- a/t/t2400-worktree-add.sh
>> +++ b/t/t2400-worktree-add.sh
>> @@ -327,8 +327,7 @@ test_expect_success 'add -B' '
>>
>>  test_expect_success 'add --quiet' '
>>  	test_when_finished "git worktree remove -f -f another-worktree" &&
>> -	test_when_finished "cat actual" &&
>> -	git worktree add --quiet another-worktree main 2>actual &&


>> +	git worktree add --quiet another-worktree main 2>actual 2>&1 &&
>>  	test_must_be_empty actual
>>  '
>>
>
> Ok scratch that. I tried checking this a bit more and it doesn't work quite
> as expected. I'll remove the `cat actual`s from the tests and if I can
> think of a better alternative, I'll report back.

While I do not understand what you are trying to achieve here, if
you expect both the standard output and error streams are quiet,
then

	cmd >output 2>&1

would store both to 'output' and test_must_be_empty can check what
is in there.

On the other hand,

	cmd 2>&1 >output

would store the standard output of 'cmd' in 'output' while sending
the standard error of 'cmd' to the standard output of the whole
thing.