[PATCH] ASoC: SOF: Intel: hda-loader: use small buffer for iccmax stream

[Peter Ujfalusi <peter.ujfalusi@linux.intel.com>]

From: Kai Vehmanen <kai.vehmanen@linux.intel.com>

The data received via iccmax stream is not used anywhere, so no need to
allocate a big DMA buffer for it. This is especially important as the
allocation is done even in cases where reload of the firmware is skipped
and execution happens directly from the firmware stored in IMR.

Signed-off-by: Kai Vehmanen <kai.vehmanen@linux.intel.com>
Reviewed-by: Péter Ujfalusi <peter.ujfalusi@linux.intel.com>
Reviewed-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Reviewed-by: Ranjani Sridharan <ranjani.sridharan@linux.intel.com>
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@linux.intel.com>
---
 sound/soc/sof/intel/hda-loader.c | 15 +++++----------
 1 file changed, 5 insertions(+), 10 deletions(-)

diff --git a/sound/soc/sof/intel/hda-loader.c b/sound/soc/sof/intel/hda-loader.c
index 3a4b0b6e2c5c..d680562edb35 100644
--- a/sound/soc/sof/intel/hda-loader.c
+++ b/sound/soc/sof/intel/hda-loader.c
@@ -322,7 +322,6 @@ int hda_dsp_cl_boot_firmware_iccmax(struct snd_sof_dev *sdev)
 {
 	struct hdac_ext_stream *iccmax_stream;
 	struct hdac_bus *bus = sof_to_bus(sdev);
-	struct firmware stripped_firmware;
 	struct snd_dma_buffer dmab_bdl;
 	int ret, ret1;
 	u8 original_gb;
@@ -330,15 +329,11 @@ int hda_dsp_cl_boot_firmware_iccmax(struct snd_sof_dev *sdev)
 	/* save the original LTRP guardband value */
 	original_gb = snd_hdac_chip_readb(bus, VS_LTRP) & HDA_VS_INTEL_LTRP_GB_MASK;
 
-	if (sdev->basefw.fw->size <= sdev->basefw.payload_offset) {
-		dev_err(sdev->dev, "error: firmware size must be greater than firmware offset\n");
-		return -EINVAL;
-	}
-
-	stripped_firmware.size = sdev->basefw.fw->size - sdev->basefw.payload_offset;
-
-	/* prepare capture stream for ICCMAX */
-	iccmax_stream = hda_cl_stream_prepare(sdev, HDA_CL_STREAM_FORMAT, stripped_firmware.size,
+	/*
+	 * Prepare capture stream for ICCMAX. We do not need to store
+	 * the data, so use a buffer of PAGE_SIZE for receiving.
+	 */
+	iccmax_stream = hda_cl_stream_prepare(sdev, HDA_CL_STREAM_FORMAT, PAGE_SIZE,
 					      &dmab_bdl, SNDRV_PCM_STREAM_CAPTURE);
 	if (IS_ERR(iccmax_stream)) {
 		dev_err(sdev->dev, "error: dma prepare for ICCMAX stream failed\n");
-- 
2.38.1