From: bugtrack@alsa-project.org
To: alsa-devel@alsa-project.org
Subject: [ALSA - driver 0001078]: intel8x0 does not work on any (?) 2.6 kernel
Date: Fri, 6 May 2005 08:59:01 +0200 [thread overview]
Message-ID: <36dab9eec2a7d4b03a59f85a84ae4d50@bugtrack.alsa-project.org> (raw)
A NOTE has been added to this issue.
======================================================================
<https://bugtrack.alsa-project.org/alsa-bug/view.php?id=1078>
======================================================================
Reported By: columbo
Assigned To:
======================================================================
Project: ALSA - driver
Issue ID: 1078
Category: PCI - intel8x0
Reproducibility: always
Severity: minor
Priority: normal
Status: new
Distribution: Slackware Linux 10.1
Kernel Version: 2.6.11.7
======================================================================
Date Submitted: 04-26-2005 21:29 CEST
Last Modified: 05-06-2005 08:59 CEST
======================================================================
Summary: intel8x0 does not work on any (?) 2.6 kernel
Description:
After compilation of ALSA drivers, libs, utilities, and after alsaconf ALSA
modules loads correctly, they are visible in lsmod and so on, but all
programs can't see sound card, /dev/dsp and so on. With kernels 2.4.x
everything is OK.
======================================================================
----------------------------------------------------------------------
gem7 - 05-06-05 08:50
----------------------------------------------------------------------
I have an HP pavilion zd7000. It worked fine up to Linux 2.6.8.1 and Alsa
1.0.4.
After that, all the way up to 2.6.12rc3 and ALSA 1.0.9rc3 no luck. So I
partially confirm this bug report.
Here are some details:
00:1f.5 Multimedia audio controller: Intel Corporation 82801EB/ER
(ICH5/ICH5R) AC'97 Audio Controller (rev 02)
Subsystem: Hewlett-Packard Company: Unknown device 006a
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 0
Interrupt: pin B routed to IRQ 17
Region 0: I/O ports at 1400 [size=256]
Region 1: I/O ports at 1c80 [size=64]
Region 2: Memory at d0000c00 (32-bit, non-prefetchable)
[size=512]
Region 3: Memory at d0000800 (32-bit, non-prefetchable)
[size=256]
Capabilities: [50] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA
PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME+
00:1f.6 Modem: Intel Corporation 82801EB/ER (ICH5/ICH5R) AC'97 Modem
Controller (rev 02) (prog-if 00 [Generic])
Subsystem: Hewlett-Packard Company: Unknown device 006a
Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Interrupt: pin B routed to IRQ 17
Region 0: I/O ports at 1800 [size=256]
Region 1: I/O ports at 1c00 [size=128]
Capabilities: [50] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA
PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=0 PME+
No /etc/asound.rc
When it worked I had two cards in /proc/asound/cards, one for the modem
and one for the sound card. Now this is all I get there:
0 [ICH5 ]: ICH4 - Intel ICH5
Intel ICH5 with unknown codec at 0xd0000c00, irq 17
# cat /proc/asound/card0/codec97#0/ac97#0-0
0-0/0: Conexant id 30
Revision : 0xff
Compat. Class : 0x1f
Subsys. Vendor ID: 0xffff
Subsys. ID : 0xffff
Capabilities : -reserved1- -headphone out-
DAC resolution : 18-bit
ADC resolution : 18-bit
3D enhancement : No 3D Stereo Enhancement
Current setup
Mic gain : +20dB [+0dB]
POP path : post 3D
Sim. stereo : on
3D enhancement : on
Loudness : on
Mono output : Mic
Mic select : Mic2
ADC/DAC loopback : on
Extended ID : codec=3 rev=3 AMAP LDAC SDAC CDAC DSA=3 VRM SPDIF DRA
VRA
Extended status : PRL PRK PRJ PRI SPCV MADC LDAC SDAC CDAC SPDIF=10/11
VRM SPDIF DRA VRA
PCM front DAC : 65535Hz
PCM Surr DAC : 65535Hz
PCM LFE DAC : 65535Hz
PCM ADC : 65535Hz
PCM MIC ADC : 65535Hz
SPDIF Control : PRO Non-audio Preemph50/15 Category=0x7f Generation=1
Rate=32kHz DRS Validity
Gain Inverted Buffer delay Location
Master Out : -10.5 dBV X 31/fs NC/unused
AUX Out : -10.5 dBV X 31/fs NC/unused
Center/LFE Out : -10.5 dBV X 31/fs NC/unused
SPDIF Out : -10.5 dBV X 31/fs NC/unused
Phone In : -10.5 dBV X 31/fs NC/unused
Mic 1 : -10.5 dBV X 31/fs NC/unused
Mic 2 : -10.5 dBV X 31/fs NC/unused
Line In : -10.5 dBV X 31/fs NC/unused
CD In : -10.5 dBV X 31/fs NC/unused
Video In : -10.5 dBV X 31/fs NC/unused
Aux In : -10.5 dBV X 31/fs NC/unused
Mono Out : -10.5 dBV X 31/fs NC/unused
Extended modem ID: codec=3 CID2 CID1 HSET LIN2 LIN1
Modem status : GPIO MREF ADC1 DAC1 ADC2 DAC2 HADC HDAC PRA(GPIO)
PRB(res) PRC(ADC1) PRD(DAC1) PRE(ADC2) PRF(DAC2) PRG(HADC) PRH(HDAC)
Line1 rate : 65535Hz
Line2 rate : 65535Hz
Headset rate : 65535Hz
# cat /proc/asound/card0/codec97/ac97#0-0+regs
0:00 = ffff
0:02 = ffff
0:04 = ffff
0:06 = ffff
0:08 = ffff
0:0a = ffff
0:0c = ffff
0:0e = ffff
0:10 = ffff
0:12 = ffff
0:14 = ffff
0:16 = ffff
0:18 = ffff
0:1a = ffff
0:1c = ffff
0:1e = ffff
0:20 = ffff
0:22 = ffff
0:24 = ffff
0:26 = ffff
0:28 = ffff
0:2a = ffff
0:2c = ffff
0:2e = ffff
0:30 = ffff
0:32 = ffff
0:34 = ffff
0:36 = ffff
0:38 = ffff
0:3a = ffff
0:3c = ffff
0:3e = ffff
0:40 = ffff
0:42 = ffff
0:44 = ffff
0:46 = ffff
0:48 = ffff
0:4a = ffff
0:4c = ffff
0:4e = ffff
0:50 = ffff
0:52 = ffff
0:54 = ffff
0:56 = ffff
0:58 = ffff
0:5a = ffff
0:5c = ffff
0:5e = ffff
0:60 = ffff
0:62 = ffff
0:64 = ffff
0:66 = ffff
0:68 = ffff
0:6a = ffff
0:6c = ffff
0:6e = ffff
0:70 = ffff
0:72 = ffff
0:74 = ffff
0:76 = ffff
0:78 = ffff
0:7a = ffff
0:7c = ffff
0:7e = ffff
Here is what I get in the system logs:
May 4 09:50:16 satchel kernel: ALSA
/usrlocal/src/ALSA/alsa-driver-1.0.9rc3/pci/../alsa-kernel/pci/intel8x0m.c:978:
Unable to initialize codec
https://bugtrack.alsa-project.org/alsa-bug/view.php?id=0
May 4 09:50:16 satchel kernel: Intel ICH Modem: probe of 0000:00:1f.6
failed wi
th error -13
May 4 09:50:29 satchel kernel: ALSA /usr/local/src/ALSA/alsa-driver-1
.0.9rc3/pci/intel8x0.c:601: codec_write 0: semaphore is not ready for
register 0
x2
May 4 09:50:29 satchel kernel: ALSA /usr/local/src/ALSA/alsa-driver-1
.0.9rc3/pci/intel8x0.c:601: codec_write 0: semaphore is not ready for
register 0
x4
Someone suggested that I add intel8x0m to /etc/hotplug/blacklist and that
did nothing. I also tried deleting intel8x0m and manually loing intel8x0
and intel8x0m in different order to no effect.
Anything else I can try?
RGDA
GARY
----------------------------------------------------------------------
pzad - 05-06-05 08:59
----------------------------------------------------------------------
Do not use snd-intel8x0m. This is source of your problems. If you load
snd-intel8x0m then it will stop your soundcard. Your modem will not work
with it anyway.
Issue History
Date Modified Username Field Change
======================================================================
04-26-05 21:29 columbo New Issue
04-26-05 21:29 columbo Distribution => Slackware Linux 10.1
04-26-05 21:29 columbo Kernel Version => 2.6.11.7
04-29-05 21:06 columbo Issue Monitored: columbo
05-06-05 08:50 gem7 Note Added: 0004590
05-06-05 08:59 pzad Note Added: 0004591
======================================================================
-------------------------------------------------------
This SF.Net email is sponsored by: NEC IT Guy Games.
Get your fingers limbered up and give it your best shot. 4 great events, 4
opportunities to win big! Highest score wins.NEC IT Guy Games. Play to
win an NEC 61 plasma display. Visit http://www.necitguy.com/?r=20
next reply other threads:[~2005-05-06 6:59 UTC|newest]
Thread overview: 10+ messages / expand[flat|nested] mbox.gz Atom feed top
2005-05-06 6:59 bugtrack [this message]
-- strict thread matches above, loose matches on Subject: below --
2005-08-09 11:44 [ALSA - driver 0001078]: intel8x0 does not work on any (?) 2.6 kernel bugtrack
2005-05-07 7:45 bugtrack
2005-05-06 18:24 bugtrack
2005-05-06 17:04 bugtrack
2005-05-06 7:33 bugtrack
2005-05-06 7:13 bugtrack
2005-05-06 7:00 bugtrack
2005-05-06 6:50 bugtrack
2005-04-26 19:29 bugtrack
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=36dab9eec2a7d4b03a59f85a84ae4d50@bugtrack.alsa-project.org \
--to=bugtrack@alsa-project.org \
--cc=alsa-devel@alsa-project.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox