From: Takashi Iwai <tiwai@suse.de>
To: "Marek Marczykowski-Górecki" <marmarek@invisiblethingslab.com>
Cc: alsa-devel@alsa-project.org, Harald Arnesen <harald@skogtun.org>,
Alex Xu <alex_y_xu@yahoo.ca>
Subject: Re: Intel HD Audio: sound stops working in Xen PV dom0 in >=5.17
Date: Tue, 17 Jan 2023 17:52:25 +0100 [thread overview]
Message-ID: <874jsp6r3q.wl-tiwai@suse.de> (raw)
In-Reply-To: <Y8bRmWMBVFVk0WZc@mail-itl>
On Tue, 17 Jan 2023 17:49:28 +0100,
Marek Marczykowski-Górecki wrote:
>
> On Tue, Jan 17, 2023 at 03:33:42PM +0100, Takashi Iwai wrote:
> > On Tue, 17 Jan 2023 15:21:23 +0100,
> > Marek Marczykowski-Górecki wrote:
> > >
> > > On Tue, Jan 17, 2023 at 12:36:28PM +0100, Marek Marczykowski-Górecki wrote:
> > > > On Tue, Jan 17, 2023 at 08:58:57AM +0100, Takashi Iwai wrote:
> > > > > On Mon, 16 Jan 2023 16:55:11 +0100,
> > > > > Takashi Iwai wrote:
> > > > > >
> > > > > > On Tue, 27 Dec 2022 16:26:54 +0100,
> > > > > > Marek Marczykowski-Górecki wrote:
> > > > > > >
> > > > > > > On Thu, Dec 22, 2022 at 09:09:15AM +0100, Takashi Iwai wrote:
> > > > > > > > On Sat, 10 Dec 2022 17:17:42 +0100,
> > > > > > > > Marek Marczykowski-Górecki wrote:
> > > > > > > > >
> > > > > > > > > On Sat, Dec 10, 2022 at 02:00:06AM +0100, Marek Marczykowski-Górecki wrote:
> > > > > > > > > > On Fri, Dec 09, 2022 at 01:40:15PM +0100, Marek Marczykowski-Górecki wrote:
> > > > > > > > > > > On Fri, Dec 09, 2022 at 09:10:19AM +0100, Takashi Iwai wrote:
> > > > > > > > > > > > On Fri, 09 Dec 2022 02:27:30 +0100,
> > > > > > > > > > > > Marek Marczykowski-Górecki wrote:
> > > > > > > > > > > > >
> > > > > > > > > > > > > Hi,
> > > > > > > > > > > > >
> > > > > > > > > > > > > Under Xen PV dom0, with Linux >= 5.17, sound stops working after few
> > > > > > > > > > > > > hours. pavucontrol still shows meter bars moving, but the speakers
> > > > > > > > > > > > > remain silent. At least on some occasions I see the following message in
> > > > > > > > > > > > > dmesg:
> > > > > > > > > > > > >
> > > > > > > > > > > > > [ 2142.484553] snd_hda_intel 0000:00:1f.3: Unstable LPIB (18144 >= 6396); disabling LPIB delay counting
> > > > > > > > > >
> > > > > > > > > > Hit the issue again, this message did not appear in the log (or at least
> > > > > > > > > > not yet).
> > > > > > > > > >
> > > > > > > > > > (...)
> > > > > > > > > >
> > > > > > > > > > > > In anyway, please check the behavior with 6.1-rc8 + the commit
> > > > > > > > > > > > cc26516374065a34e10c9a8bf3e940e42cd96e2a
> > > > > > > > > > > > ALSA: memalloc: Allocate more contiguous pages for fallback case
> > > > > > > > > > > > from for-next of my sound git tree (which will be in 6.2-rc1).
> > > > > > > > > >
> > > > > > > > > > This did not helped.
> > > > > > > > > >
> > > > > > > > > > > Looking at the mentioned commits, there is one specific aspect of Xen PV
> > > > > > > > > > > that may be relevant. It configures PAT differently than native Linux.
> > > > > > > > > > > Theoretically Linux adapts automatically and using proper API (like
> > > > > > > > > > > set_memory_wc()) should just work, but at least for i915 driver it
> > > > > > > > > > > causes issues (not fully tracked down yet). Details about that bug
> > > > > > > > > > > report include some more background:
> > > > > > > > > > > https://lore.kernel.org/intel-gfx/Y5Hst0bCxQDTN7lK@mail-itl/
> > > > > > > > > > >
> > > > > > > > > > > Anyway, I have tested it on a Xen modified to setup PAT the same way as
> > > > > > > > > > > native Linux and the audio issue is still there.
> > > > > > > > > > >
> > > > > > > > > > > > If the problem persists, another thing to check is the hack below
> > > > > > > > > > > > works.
> > > > > > > > > >
> > > > > > > > > > Trying this one now.
> > > > > > > > >
> > > > > > > > > And this one didn't either :/
> > > > > > > >
> > > > > > > > (Sorry for the late reply, as I've been off in the last weeks.)
> > > > > > > >
> > > > > > > > I think the hack doesn't influence on the PCM buffer pages, but only
> > > > > > > > about BDL pages. Could you check the patch below instead?
> > > > > > > > It'll disable the SG-buffer handling on x86 completely.
> > > > > > >
> > > > > > > This seems to "fix" the issue, thanks!
> > > > > > > I guess I'll run it this way for now, but a proper solution would be
> > > > > > > nice. Let me know if I can collect any more info that would help with
> > > > > > > that.
> > > > > >
> > > > > > Then we seem to go back again with the coherent memory allocation for
> > > > > > the fallback sg cases. It was changed because the use of
> > > > > > dma_alloc_coherent() caused a problem with IOMMU case for retrieving
> > > > > > the page addresses, but since the commit 9736a325137b, we essentially
> > > > > > avoid the fallback when IOMMU is used, so it should be fine again.
> > > > > >
> > > > > > Let me know if the patch like below works for you instead of the
> > > > > > previous hack to disable SG-buffer (note: totally untested!)
> > > > >
> > > > > Gah, there was an obvious typo, scratch that.
> > > > >
> > > > > Below is a proper patch. Please try this one instead.
> > > >
> > > > Thanks, I'll give it a try.
> > >
> > > Unfortunately, it doesn't help, it stopped working again, after about 3h
> > > uptime.
> >
> > Aha, then it might be rather other way round;
> > dma_alloc_noncontiguous() doesn't work on Xen properly.
> >
> > Could you try the one below instead of the previous?
>
> Unfortunately, this one doesn't fix it either :/
Hmm. Then how about applying both of the last two patches? The last
one to enforce the fallback allocation and the previous one to use
dma_alloc_coherent(). It should be essentially reverting to the old
way.
Takashi
next prev parent reply other threads:[~2023-01-17 16:53 UTC|newest]
Thread overview: 25+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <Y5KPAs6f7S2dEoxR@mail-itl>
2022-12-09 8:10 ` Intel HD Audio: sound stops working in Xen PV dom0 in >=5.17 Takashi Iwai
2022-12-09 12:40 ` Marek Marczykowski-Górecki
2022-12-10 1:00 ` Marek Marczykowski-Górecki
2022-12-10 16:17 ` Marek Marczykowski-Górecki
2022-12-20 4:43 ` Marek Marczykowski-Górecki
2022-12-22 8:09 ` Takashi Iwai
2022-12-27 15:26 ` Marek Marczykowski-Górecki
2023-01-16 15:55 ` Takashi Iwai
2023-01-17 7:58 ` Takashi Iwai
2023-01-17 11:36 ` Marek Marczykowski-Górecki
2023-01-17 14:21 ` Marek Marczykowski-Górecki
2023-01-17 14:33 ` Takashi Iwai
2023-01-17 16:49 ` Marek Marczykowski-Górecki
2023-01-17 16:52 ` Takashi Iwai [this message]
2023-01-17 20:34 ` Marek Marczykowski-Górecki
2023-01-18 8:59 ` Takashi Iwai
2023-01-18 10:39 ` Marek Marczykowski-Górecki
2023-01-18 12:39 ` Takashi Iwai
2023-01-20 1:10 ` Marek Marczykowski-Górecki
2023-01-20 2:24 ` Marek Marczykowski-Górecki
2023-01-20 7:26 ` Takashi Iwai
2023-01-20 12:11 ` Marek Marczykowski-Górecki
2023-01-20 13:19 ` Takashi Iwai
2023-01-23 21:31 ` Marek Marczykowski-Górecki
2023-01-24 9:24 ` Takashi Iwai
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=874jsp6r3q.wl-tiwai@suse.de \
--to=tiwai@suse.de \
--cc=alex_y_xu@yahoo.ca \
--cc=alsa-devel@alsa-project.org \
--cc=harald@skogtun.org \
--cc=marmarek@invisiblethingslab.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox