From: Mohammed Shafi Shajakhan <mohammed@qti.qualcomm.com>
To: ath10k@lists.infradead.org
Cc: mohammed@codeaurora.org, Kalle Valo <kvalo@qca.qualcomm.com>,
linux-wireless@vger.kernel.org, kvalo@codeaurora.org,
Mohammed Shafi Shajakhan <mohammed@qti.qualcomm.com>
Subject: [PATCH 2/2] ath10k: Enable parsing per station rx duration for 10.4
Date: Tue, 15 Mar 2016 20:00:50 +0530 [thread overview]
Message-ID: <1458052250-2529-3-git-send-email-mohammed@qca.qualcomm.com> (raw)
In-Reply-To: <1458052250-2529-1-git-send-email-mohammed@qca.qualcomm.com>
From: Mohammed Shafi Shajakhan <mohammed@qti.qualcomm.com>
Rx duration support for per station is part of extended peer
stats, enable provision to parse the same and provide backward
compatibility based on the 'stats_id' event
Signed-off-by: Mohammed Shafi Shajakhan <mohammed@qti.qualcomm.com>
---
drivers/net/wireless/ath/ath10k/core.c | 19 ++++++++++++++++++-
drivers/net/wireless/ath/ath10k/wmi.c | 30 ++++++++++++++++++++++++------
drivers/net/wireless/ath/ath10k/wmi.h | 16 ++++++++++++++++
3 files changed, 58 insertions(+), 7 deletions(-)
diff --git a/drivers/net/wireless/ath/ath10k/core.c b/drivers/net/wireless/ath/ath10k/core.c
index 2389c07..5e37e61 100644
--- a/drivers/net/wireless/ath/ath10k/core.c
+++ b/drivers/net/wireless/ath/ath10k/core.c
@@ -1534,7 +1534,8 @@ static int ath10k_core_init_firmware_features(struct ath10k *ar)
ar->num_active_peers = TARGET_10_4_ACTIVE_PEERS;
ar->max_num_vdevs = TARGET_10_4_NUM_VDEVS;
ar->num_tids = TARGET_10_4_TGT_NUM_TIDS;
- ar->fw_stats_req_mask = WMI_STAT_PEER;
+ ar->fw_stats_req_mask = WMI_10_4_STAT_PEER |
+ WMI_10_4_STAT_PEER_EXTD;
ar->max_spatial_stream = ar->hw_params.max_spatial_stream;
if (test_bit(ATH10K_FW_FEATURE_PEER_FLOW_CONTROL,
@@ -1579,6 +1580,7 @@ static int ath10k_core_init_firmware_features(struct ath10k *ar)
int ath10k_core_start(struct ath10k *ar, enum ath10k_firmware_mode mode)
{
int status;
+ u32 val;
lockdep_assert_held(&ar->conf_mutex);
@@ -1699,6 +1701,21 @@ int ath10k_core_start(struct ath10k *ar, enum ath10k_firmware_mode mode)
ath10k_dbg(ar, ATH10K_DBG_BOOT, "firmware %s booted\n",
ar->hw->wiphy->fw_version);
+ if (test_bit(WMI_SERVICE_EXT_RES_CFG_SUPPORT, ar->wmi.svc_map)) {
+ val = 0;
+ if (ath10k_peer_stats_enabled(ar))
+ val = WMI_10_4_PEER_STATS;
+
+ status = ath10k_wmi_ext_resource_config(ar,
+ WMI_HOST_PLATFORM_HIGH_PERF, val);
+ if (status) {
+ ath10k_err(ar,
+ "failed to send ext resource cfg command : %d\n",
+ status);
+ goto err_hif_stop;
+ }
+ }
+
status = ath10k_wmi_cmd_init(ar);
if (status) {
ath10k_err(ar, "could not send WMI init command (%d)\n",
diff --git a/drivers/net/wireless/ath/ath10k/wmi.c b/drivers/net/wireless/ath/ath10k/wmi.c
index fcef9a0..7542ed8 100644
--- a/drivers/net/wireless/ath/ath10k/wmi.c
+++ b/drivers/net/wireless/ath/ath10k/wmi.c
@@ -2632,6 +2632,16 @@ void ath10k_wmi_pull_peer_stats(const struct wmi_peer_stats *src,
dst->peer_tx_rate = __le32_to_cpu(src->peer_tx_rate);
}
+static void
+ath10k_wmi_10_4_pull_peer_stats(const struct wmi_10_4_peer_stats *src,
+ struct ath10k_fw_stats_peer *dst)
+{
+ ether_addr_copy(dst->peer_macaddr, src->peer_macaddr.addr);
+ dst->peer_rssi = __le32_to_cpu(src->peer_rssi);
+ dst->peer_tx_rate = __le32_to_cpu(src->peer_tx_rate);
+ dst->peer_rx_rate = __le32_to_cpu(src->peer_rx_rate);
+}
+
static int ath10k_wmi_main_op_pull_fw_stats(struct ath10k *ar,
struct sk_buff *skb,
struct ath10k_fw_stats *stats)
@@ -2925,6 +2935,7 @@ static int ath10k_wmi_10_4_op_pull_fw_stats(struct ath10k *ar,
u32 num_pdev_ext_stats;
u32 num_vdev_stats;
u32 num_peer_stats;
+ u32 stats_id;
int i;
if (!skb_pull(skb, sizeof(*ev)))
@@ -2934,6 +2945,7 @@ static int ath10k_wmi_10_4_op_pull_fw_stats(struct ath10k *ar,
num_pdev_ext_stats = __le32_to_cpu(ev->num_pdev_ext_stats);
num_vdev_stats = __le32_to_cpu(ev->num_vdev_stats);
num_peer_stats = __le32_to_cpu(ev->num_peer_stats);
+ stats_id = __le32_to_cpu(ev->stats_id);
for (i = 0; i < num_pdev_stats; i++) {
const struct wmi_10_4_pdev_stats *src;
@@ -2973,22 +2985,28 @@ static int ath10k_wmi_10_4_op_pull_fw_stats(struct ath10k *ar,
/* fw doesn't implement vdev stats */
for (i = 0; i < num_peer_stats; i++) {
- const struct wmi_10_4_peer_stats *src;
+ const struct wmi_10_4_peer_extd_stats *src;
struct ath10k_fw_stats_peer *dst;
+ int stats_len;
+ bool extd_peer_stats = !!(stats_id & WMI_10_4_STAT_PEER_EXTD);
+
+ if (extd_peer_stats)
+ stats_len = sizeof(struct wmi_10_4_peer_extd_stats);
+ else
+ stats_len = sizeof(struct wmi_10_4_peer_stats);
src = (void *)skb->data;
- if (!skb_pull(skb, sizeof(*src)))
+ if (!skb_pull(skb, stats_len))
return -EPROTO;
dst = kzalloc(sizeof(*dst), GFP_ATOMIC);
if (!dst)
continue;
- ether_addr_copy(dst->peer_macaddr, src->peer_macaddr.addr);
- dst->peer_rssi = __le32_to_cpu(src->peer_rssi);
- dst->peer_tx_rate = __le32_to_cpu(src->peer_tx_rate);
- dst->peer_rx_rate = __le32_to_cpu(src->peer_rx_rate);
+ ath10k_wmi_10_4_pull_peer_stats(&src->common, dst);
/* FIXME: expose 10.4 specific values */
+ if (extd_peer_stats)
+ dst->rx_duration = src->rx_duration;
list_add_tail(&dst->list, &stats->peers);
}
diff --git a/drivers/net/wireless/ath/ath10k/wmi.h b/drivers/net/wireless/ath/ath10k/wmi.h
index 1d3e085..8626bb1 100644
--- a/drivers/net/wireless/ath/ath10k/wmi.h
+++ b/drivers/net/wireless/ath/ath10k/wmi.h
@@ -4104,6 +4104,13 @@ enum wmi_stats_id {
WMI_STAT_VDEV_RATE = BIT(5),
};
+enum wmi_10_4_stats_id {
+ WMI_10_4_STAT_PEER = BIT(0),
+ WMI_10_4_STAT_AP = BIT(1),
+ WMI_10_4_STAT_INST = BIT(2),
+ WMI_10_4_STAT_PEER_EXTD = BIT(3),
+};
+
struct wlan_inst_rssi_args {
__le16 cfg_retry_count;
__le16 retry_count;
@@ -4303,6 +4310,15 @@ struct wmi_10_4_peer_stats {
__le32 peer_rssi_changed;
} __packed;
+struct wmi_10_4_peer_extd_stats {
+ struct wmi_10_4_peer_stats common;
+ struct wmi_mac_addr peer_macaddr;
+ __le32 inactive_time;
+ __le32 peer_chain_rssi;
+ __le32 rx_duration;
+ __le32 reserved[10];
+} __packed;
+
struct wmi_10_2_pdev_ext_stats {
__le32 rx_rssi_comb;
__le32 rx_rssi[4];
--
1.7.9.5
_______________________________________________
ath10k mailing list
ath10k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath10k
next prev parent reply other threads:[~2016-03-15 14:32 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-03-15 14:30 [PATCH 0/2] Parsing per station rx duration for 10.4 Mohammed Shafi Shajakhan
2016-03-15 14:30 ` [PATCH 1/2] ath10k: Introduce Extended Resource Config support " Mohammed Shafi Shajakhan
2016-03-16 10:21 ` Valo, Kalle
2016-03-16 11:16 ` Mohammed Shafi Shajakhan
2016-03-15 14:30 ` Mohammed Shafi Shajakhan [this message]
2016-03-16 10:22 ` [PATCH 2/2] ath10k: Enable parsing per station rx duration " Valo, Kalle
2016-03-16 11:19 ` Mohammed Shafi Shajakhan
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1458052250-2529-3-git-send-email-mohammed@qca.qualcomm.com \
--to=mohammed@qti.qualcomm.com \
--cc=ath10k@lists.infradead.org \
--cc=kvalo@codeaurora.org \
--cc=kvalo@qca.qualcomm.com \
--cc=linux-wireless@vger.kernel.org \
--cc=mohammed@codeaurora.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox