From: Wen Gong <wgong@codeaurora.org>
To: ath10k@lists.infradead.org
Cc: linux-wireless@vger.kernel.org
Subject: [PATCH] ath10k: Convert wow pattern from 802.3 to 802.11
Date: Fri, 30 Mar 2018 11:18:19 +0800 [thread overview]
Message-ID: <1522379899-31969-1-git-send-email-wgong@codeaurora.org> (raw)
When trying to set wow wakeup patterns it fails with this command:
iw phyxx wowlan enable patterns offset xx+ IP address xx.xx.xx.xx
The reason is that the wow pattern from upper layer is in 802.3 format
for this case, it need to convert it to 802.11 format. The input
offset parameter is used for 802.3, but the actual offset firmware
need depends on rx_decap_mode, so that it needs to be recalculated.
Pattern of 802.3 packet is not same with 802.11 packet. If the
rx_decap_mode is ATH10K_HW_TXRX_NATIVE_WIFI, then firmware will
receive data packet with 802.11 format from hardware.
Convert graph:
-----------------------------------------------------------------------
802.3 |dest mac(6B)|src mac(6B)|type(2B)| body... |
|__ |_______ |_____________ |___________
| | | |
802.11 |4B|dest mac(6B)| 6B |src mac(6B)| 8B |type(2B)| body... |
-----------------------------------------------------------------------
Tested with QCA6174 hw3.0 with firmware
WLAN.RM.4.4.1-00099-QCARMSWPZ-1, but this will also affect QCA9377.
This has always failed, so it's not a regression with new firmware
releases.
Signed-off-by: Wen Gong <wgong@codeaurora.org>
---
drivers/net/wireless/ath/ath10k/wmi.h | 4 ++
drivers/net/wireless/ath/ath10k/wow.c | 128 ++++++++++++++++++++++++++++++++--
2 files changed, 126 insertions(+), 6 deletions(-)
diff --git a/drivers/net/wireless/ath/ath10k/wmi.h b/drivers/net/wireless/ath/ath10k/wmi.h
index c7b30ed..389f9c7 100644
--- a/drivers/net/wireless/ath/ath10k/wmi.h
+++ b/drivers/net/wireless/ath/ath10k/wmi.h
@@ -6724,6 +6724,10 @@ struct wmi_wow_ev_arg {
#define WOW_MIN_PATTERN_SIZE 1
#define WOW_MAX_PATTERN_SIZE 148
#define WOW_MAX_PKT_OFFSET 128
+#define WOW_HDR_LEN (sizeof(struct ieee80211_hdr_3addr) + \
+ sizeof(struct rfc1042_hdr))
+#define WOW_MAX_REDUCE (WOW_HDR_LEN - sizeof(struct ethhdr) - \
+ offsetof(struct ieee80211_hdr_3addr, addr1))
enum wmi_tdls_state {
WMI_TDLS_DISABLE,
diff --git a/drivers/net/wireless/ath/ath10k/wow.c b/drivers/net/wireless/ath/ath10k/wow.c
index c4cbccb..9b56a41 100644
--- a/drivers/net/wireless/ath/ath10k/wow.c
+++ b/drivers/net/wireless/ath/ath10k/wow.c
@@ -1,5 +1,6 @@
/*
* Copyright (c) 2015-2017 Qualcomm Atheros, Inc.
+ * Copyright (c) 2018, The Linux Foundation. All rights reserved.
*
* Permission to use, copy, modify, and/or distribute this software for any
* purpose with or without fee is hereby granted, provided that the above
@@ -76,6 +77,98 @@ static int ath10k_wow_cleanup(struct ath10k *ar)
return 0;
}
+static void ath10k_wow_convert_8023_to_80211
+ (struct cfg80211_pkt_pattern *new,
+ const struct cfg80211_pkt_pattern *old)
+{
+ u8 hdr_8023_pattern[ETH_HLEN] = {};
+ u8 hdr_8023_bit_mask[ETH_HLEN] = {};
+ u8 hdr_80211_pattern[WOW_HDR_LEN] = {};
+ u8 hdr_80211_bit_mask[WOW_HDR_LEN] = {};
+
+ int total_len = old->pkt_offset + old->pattern_len;
+ int hdr_80211_end_offset;
+
+ struct ieee80211_hdr_3addr *new_hdr_pattern =
+ (struct ieee80211_hdr_3addr *)hdr_80211_pattern;
+ struct ieee80211_hdr_3addr *new_hdr_mask =
+ (struct ieee80211_hdr_3addr *)hdr_80211_bit_mask;
+ struct ethhdr *old_hdr_pattern = (struct ethhdr *)hdr_8023_pattern;
+ struct ethhdr *old_hdr_mask = (struct ethhdr *)hdr_8023_bit_mask;
+ int hdr_len = sizeof(*new_hdr_pattern);
+
+ struct rfc1042_hdr *new_rfc_pattern =
+ (struct rfc1042_hdr *)(hdr_80211_pattern + hdr_len);
+ struct rfc1042_hdr *new_rfc_mask =
+ (struct rfc1042_hdr *)(hdr_80211_bit_mask + hdr_len);
+ int rfc_len = sizeof(*new_rfc_pattern);
+
+ memcpy(hdr_8023_pattern + old->pkt_offset,
+ old->pattern, ETH_HLEN - old->pkt_offset);
+ memcpy(hdr_8023_bit_mask + old->pkt_offset,
+ old->mask, ETH_HLEN - old->pkt_offset);
+
+ /* Copy destination address */
+ memcpy(new_hdr_pattern->addr1, old_hdr_pattern->h_dest, ETH_ALEN);
+ memcpy(new_hdr_mask->addr1, old_hdr_mask->h_dest, ETH_ALEN);
+
+ /* Copy source address */
+ memcpy(new_hdr_pattern->addr3, old_hdr_pattern->h_source, ETH_ALEN);
+ memcpy(new_hdr_mask->addr3, old_hdr_mask->h_source, ETH_ALEN);
+
+ /* Copy logic link type */
+ memcpy(&new_rfc_pattern->snap_type,
+ &old_hdr_pattern->h_proto,
+ sizeof(old_hdr_pattern->h_proto));
+ memcpy(&new_rfc_mask->snap_type,
+ &old_hdr_mask->h_proto,
+ sizeof(old_hdr_mask->h_proto));
+
+ /* Caculate new pkt_offset */
+ if (old->pkt_offset < ETH_ALEN)
+ new->pkt_offset = old->pkt_offset +
+ offsetof(struct ieee80211_hdr_3addr, addr1);
+ else if (old->pkt_offset < offsetof(struct ethhdr, h_proto))
+ new->pkt_offset = old->pkt_offset +
+ offsetof(struct ieee80211_hdr_3addr, addr3) -
+ offsetof(struct ethhdr, h_source);
+ else
+ new->pkt_offset = old->pkt_offset + hdr_len + rfc_len - ETH_HLEN;
+
+ /* Caculate new hdr end offset */
+ if (total_len > ETH_HLEN)
+ hdr_80211_end_offset = hdr_len + rfc_len;
+ else if (total_len > offsetof(struct ethhdr, h_proto))
+ hdr_80211_end_offset = hdr_len + rfc_len + total_len - ETH_HLEN;
+ else if (total_len > ETH_ALEN)
+ hdr_80211_end_offset = total_len - ETH_ALEN +
+ offsetof(struct ieee80211_hdr_3addr, addr3);
+ else
+ hdr_80211_end_offset = total_len +
+ offsetof(struct ieee80211_hdr_3addr, addr1);
+
+ new->pattern_len = hdr_80211_end_offset - new->pkt_offset;
+
+ memcpy((u8 *)new->pattern,
+ hdr_80211_pattern + new->pkt_offset,
+ new->pattern_len);
+ memcpy((u8 *)new->mask,
+ hdr_80211_bit_mask + new->pkt_offset,
+ new->pattern_len);
+
+ if (total_len > ETH_HLEN) {
+ /* Copy frame body */
+ memcpy((u8 *)new->pattern + new->pattern_len,
+ (void *)old->pattern + ETH_HLEN - old->pkt_offset,
+ total_len - ETH_HLEN);
+ memcpy((u8 *)new->mask + new->pattern_len,
+ (void *)old->mask + ETH_HLEN - old->pkt_offset,
+ total_len - ETH_HLEN);
+
+ new->pattern_len += total_len - ETH_HLEN;
+ }
+}
+
static int ath10k_vif_wow_set_wakeups(struct ath10k_vif *arvif,
struct cfg80211_wowlan *wowlan)
{
@@ -116,22 +209,39 @@ static int ath10k_vif_wow_set_wakeups(struct ath10k_vif *arvif,
for (i = 0; i < wowlan->n_patterns; i++) {
u8 bitmask[WOW_MAX_PATTERN_SIZE] = {};
+ u8 ath_pattern[WOW_MAX_PATTERN_SIZE] = {};
+ u8 ath_bitmask[WOW_MAX_PATTERN_SIZE] = {};
+ struct cfg80211_pkt_pattern new_pattern = {};
+ struct cfg80211_pkt_pattern old_pattern = patterns[i];
int j;
-
+ new_pattern.pattern = ath_pattern;
+ new_pattern.mask = ath_bitmask;
if (patterns[i].pattern_len > WOW_MAX_PATTERN_SIZE)
continue;
-
/* convert bytemask to bitmask */
for (j = 0; j < patterns[i].pattern_len; j++)
if (patterns[i].mask[j / 8] & BIT(j % 8))
bitmask[j] = 0xff;
+ old_pattern.mask = bitmask;
+ new_pattern = old_pattern;
+
+ if (ar->wmi.rx_decap_mode == ATH10K_HW_TXRX_NATIVE_WIFI) {
+ if (patterns[i].pkt_offset < ETH_HLEN)
+ ath10k_wow_convert_8023_to_80211(&new_pattern,
+ &old_pattern);
+ else
+ new_pattern.pkt_offset += WOW_HDR_LEN - ETH_HLEN;
+ }
+
+ if (WARN_ON(new_pattern.pattern_len > WOW_MAX_PATTERN_SIZE))
+ return -EINVAL;
ret = ath10k_wmi_wow_add_pattern(ar, arvif->vdev_id,
pattern_id,
- patterns[i].pattern,
- bitmask,
- patterns[i].pattern_len,
- patterns[i].pkt_offset);
+ new_pattern.pattern,
+ new_pattern.mask,
+ new_pattern.pattern_len,
+ new_pattern.pkt_offset);
if (ret) {
ath10k_warn(ar, "failed to add pattern %i to vdev %i: %d\n",
pattern_id,
@@ -345,6 +455,12 @@ int ath10k_wow_init(struct ath10k *ar)
return -EINVAL;
ar->wow.wowlan_support = ath10k_wowlan_support;
+
+ if (ar->wmi.rx_decap_mode == ATH10K_HW_TXRX_NATIVE_WIFI) {
+ ar->wow.wowlan_support.pattern_max_len -= WOW_MAX_REDUCE;
+ ar->wow.wowlan_support.max_pkt_offset -= WOW_MAX_REDUCE;
+ }
+
ar->wow.wowlan_support.n_patterns = ar->wow.max_num_patterns;
ar->hw->wiphy->wowlan = &ar->wow.wowlan_support;
--
2.7.4
_______________________________________________
ath10k mailing list
ath10k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath10k
next reply other threads:[~2018-03-30 3:19 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-03-30 3:18 Wen Gong [this message]
2018-04-11 23:13 ` [PATCH] ath10k: Convert wow pattern from 802.3 to 802.11 Brian Norris
2018-04-12 3:31 ` Wen Gong
2018-04-12 4:18 ` Wen Gong
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1522379899-31969-1-git-send-email-wgong@codeaurora.org \
--to=wgong@codeaurora.org \
--cc=ath10k@lists.infradead.org \
--cc=linux-wireless@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox