QCA4019 firmware: wrong numChain setting for bmi-board 16+17

[Sven Eckelmann <sven.eckelmann@openmesh.com>]

[-- Attachment #1.1: Type: text/plain, Size: 1090 bytes --]

Hi,

I've just noticed that the numChain in (ath10k/)QCA4019/hw1.0/board-2.bin is
wrong in the bus=ahb,bmi-chip-id=0,bmi-board-id=16 and
bus=ahb,bmi-chip-id=0,bmi-board-id=17 from the linux-firmware and
ath10k-firmware repository. It is 0x4 for a 2x2 device. This was fixed in
the QSDK by commit 171b9607fb8cc694ed469a4e29c91af9d92f2971 [1]. It is not
known to me whether this has an effect when the pre-cal data says that the
device should use numChain 2.

It is also currently unknown if this is actually the correct fieldname
(it is just called numChain_A_0_0 [2] in some text files we got from the
netgear GPL drop [2]). But I am talking about the byte at offset 0x2771.
The only other change in these two boarddata sections is the CRC.

Kind regards,
	Sven

[1] https://source.codeaurora.org/quic/qsdk/oss/firmware/ath10k-firmware/commit/ath10k/QCA40XX/hw1.0/board-2.bin?id=171b9607fb8cc694ed469a4e29c91af9d92f2971
[2] https://github.com/paul-chambers/netgear-r7800/blob/master/git_home/madwifi-11n.git/halphy_tools/host/eepromUtil/release_ipq4019/boardData_1_0_IPQ4019_Y9803_wifi1.txt

[-- Attachment #1.2: This is a digitally signed message part. --]
[-- Type: application/pgp-signature, Size: 833 bytes --]

[-- Attachment #2: Type: text/plain, Size: 146 bytes --]

_______________________________________________
ath10k mailing list
ath10k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath10k