Re: Throughput is very low

[Bart Jooris <Bart.Jooris@intec.ugent.be>]

Dear Mamum,

On 07/09/2014 04:22 PM, Mamun Abu-Tair wrote:
> Dear all,
> I am trying to do throughput test with copmex AC cards Model (WLE900VX 7AA) .,using hostapd running on the server and  one client.
I have some cards with the same label. Hostapd on the server, on the 
station we use wpa_supplicant.
>
> I used Kalle sitting for the hostapd. However, the maximum throughput i can get is around 70Mbit/s which is far away from the throughput achieved by many users (UDP traffic).
In a setup with those cards we can observe a UDP throughput of approx. 
640Mbps.

>
> I have notice that Bit Rate keeps fixed 6 Mb/s . and it dose not responding to any commands to change it.
While running iperf client on the station I can also retrieve the Tx 
bitrate of 6Mbps with both iwconfig and 'iw wlanX station dump'. Version 
of iw has some impact on the output too, I have version 3.15.  I don't 
know a tool which shows the right info on the transmitting node...
But a third node which is configured as a sniffer shows Tx bitrate of 
1299.99Mbps :-)

>
> The machines used:
>   Ubuntu 12.04, Kerenl 3.16 , updated regulatory to cover 80Mhz channels , and the latest  firmware
Our nodes are also running 12.04 but still with the default kernel 
3.11.0-15-generic.
dmesg | grep qca98 shows
[    4.594975] ath10k: qca988x hw2.0 (0x4100016c) fw 10.1.467.2-1 api 2 
htt 2.1
Further, as Kalle suggested, we installed the ath10k driver from 
backports-3.15.1-1.

Best regards,

Bart

-- 
Bart Jooris
Department of Information Technology
Internet Based Communication Networks and Services (IBCN)
Ghent University - iMinds
Gaston Crommenlaan 8 (Bus 201), B-9050 Gent, Belgium
E-mail: bart.jooris@intec.UGent.be
M: +32 474 59 53 42
Tel. +32 9 33 14900
Fax +32 9 33 14899


_______________________________________________
ath10k mailing list
ath10k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath10k