Re:

[Peter Oh <poh@codeaurora.org>]

On 01/13/2016 09:36 PM, Alexey Ivanov wrote:
> Yes, you're right, Michał
> putting cal.bin to lib/firmware/ath10k helped
> (before I put it to lib/firmware/ath10k/QCA988X/hw2.0/)
>
> but the mac address is still 00:03:7F:00:00:00
cal file has a mac address in it and ath10k uses it as default unless 
some other scripts change it during boot.
> the output now is:
> [   11.381198] ath10k_pci 0000:00:00.0: pci irq legacy interrupts 0
> irq_mode 0 reset_mode 0
> [   11.725833] ath10k_pci 0000:00:00.0: qca988x hw2.0 target
> 0x4100016c chip_id 0x043202ff sub 0000:0000
> [   11.735226] ath10k_pci 0000:00:00.0: kconfig debug 1 debugfs 1
> tracing 0 dfs 0 testmode 1
> [   11.748288] ath10k_pci 0000:00:00.0: firmware ver 10.2.4.97 api 5
> features no-p2p crc32 f91e34f2
> [   11.797377] ath10k_pci 0000:00:00.0: Direct firmware load for
> ath10k/QCA988X/hw2.0/board-2.bin failed with error -2
> [   11.807985] ath10k_pci 0000:00:00.0: Falling back to user helper
> [   11.882960] firmware ath10k!QCA988X!hw2.0!board-2.bin:
> firmware_loading_store: map pages failed
> [   11.893044] ath10k_pci 0000:00:00.0: board_file api 1 bmi_id N/A
> crc32 e623b3be
> [   12.947352] ath10k_pci 0000:00:00.0: htt-ver 2.1 wmi-op 5 htt-op 2
> cal file max-sta 128 raw 0 hwcrypto 1
>
> As I understand, after correct calibration there should be normal mac?
>
> On 13 January 2016 at 18:54, Michal Kazior <michal.kazior@tieto.com> wrote:
>> On 13 January 2016 at 15:45, Alexey Ivanov <alexeyivan@gmail.com> wrote:
>>>> Strange..
>>> Do you have any idea what it can be?
>>> "map pages failed" seems to be a result of failing to vmap() buffer in
>>> fw_map_pages_buf() in firmware_loading_store()
>> It's the same message as when you didn't have the cal.bin file at all.
>> Are you sure you placed it correctly? Perhaps a filename typo?
>>
>> Another idea is initramfs which is used during early boot and which
>> doesn't include files from rootfs (meaning you'd have to rebuild it) -
>> not sure if this is the case though. You can rule it out by reloading
>> the driver after booting so that it surely has access to your rootfs's
>> /lib/firmware:
>>
>>    rmmod ath10k_pci && modprobe ath10k_pci
>>
>>
>> Michał
>
>


_______________________________________________
ath10k mailing list
ath10k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath10k