messages from 2014-12-01 07:48:21 to 2015-01-07 09:07:15 UTC [more...]
[PATCH 0/5] ath10k: new beaconning methods for AP/GO/IBSS
2015-01-07 9:06 UTC (9+ messages)
` [PATCH 1/5] ath10k: implement new beacon tx status event
` [PATCH 2/5] ath10k: implement beacon template command
` [PATCH 3/5] ath10k: implement prb tmpl wmi command
` [PATCH 4/5] ath10k: implement p2p bcn ie command
` [PATCH 5/5] ath10k: implement support for ap beacon offloading
number of peers exceeded after a short time
2015-01-07 8:07 UTC (3+ messages)
Firmware debug messages stopped sometime after 3.18
2015-01-06 20:42 UTC (4+ messages)
` Firmware debug messages stopped sometime after 3.18 (bisected)
Clean up scan when start fails?
2015-01-05 19:04 UTC
patch to enable LDPC / STBC sniffing with ath10k
2015-01-05 10:03 UTC
[PATCH] ath10k: Remove unused variable
2015-01-05 4:40 UTC
[PATCH] ath10k: Make HTT fill size configurable
2015-01-05 4:39 UTC
[PATCH] ath10k: Enable RX batching
2015-01-02 13:33 UTC (6+ messages)
[PATCH] ath10k: Fix DMA burst size
2015-01-02 7:41 UTC (2+ messages)
Checking on interest in some patches
2014-12-31 20:01 UTC
[PATCH v2] ath10k: fixup wait_for_completion_timeout return handling
2014-12-30 19:44 UTC
[PATCH 0/4] ath10k: a few incorrect return handling fix-up
2014-12-30 19:42 UTC (9+ messages)
` [PATCH 1/4] ath10k: fixup wait_for_completion_timeout return handling
` [PATCH 2/4] "
` [PATCH 3/4] "
` [PATCH 4/4] "
Reproducible issue in hacked 3.17 kernel, CT firmware
2014-12-30 19:18 UTC
[PATCH 0/8] fix error return code
2014-12-29 17:04 UTC (2+ messages)
` [PATCH 8/8] ath10k: "
TX statistics
2014-12-27 19:44 UTC
[PATCH] ath: fix incorrect PPB on FCC radar type 5
2014-12-24 15:29 UTC (4+ messages)
num_rf_chains problem
2014-12-24 14:46 UTC (4+ messages)
[PATCH] ath10k: fix build error when hwmon is off
2014-12-24 11:24 UTC
[PATCH 0/8] ath10k: add per station debugfs support
2014-12-24 8:11 UTC (13+ messages)
` [PATCH 1/8] ath10k: add wmi support for addba_clear_resp
` [PATCH 2/8] ath10k: add wmi support for addba_send
` [PATCH 3/8] ath10k: add wmi support for addba_set_resp
` [PATCH 4/8] ath10k: add wmi support for delba_send
` [PATCH 5/8] ath10k: Implement sta_add_debugfs
` [PATCH 6/8] ath10k: add support to send addba request
` [PATCH 7/8] ath10k: add support to send addba response
` [PATCH 8/8] ath10k: ath10k: add support to send delba
[PATCH v2 0/8] ath10k: add per station debugfs support
2014-12-24 7:59 UTC (9+ messages)
` [PATCH v2 1/8] ath10k: add wmi support for addba_clear_resp
` [PATCH v2 2/8] ath10k: add wmi support for addba_send
` [PATCH v2 3/8] ath10k: add wmi support for addba_set_resp
` [PATCH v2 4/8] ath10k: add wmi support for delba_send
` [PATCH v2 5/8] ath10k: Implement sta_add_debugfs
` [PATCH v2 6/8] ath10k: add support to send addba request
` [PATCH v2 7/8] ath10k: add support to send addba response
` [PATCH v2 8/8] ath10k: add support to send delba
[PATCH v2 0/8] ath10k: Add thermal mitigation support
2014-12-23 19:52 UTC (13+ messages)
` [PATCH v2 1/8] ath10k: set max_num_vdevs based on wmi op version
` [PATCH v2 2/8] ath10k: use wmi op version to check which iface combination to use
` [PATCH v2 3/8] ath10k: print ath10k wmi op version
` [PATCH v2 4/8] ath10k: add 10.2.4 firmware support
` [PATCH v2 5/8] ath10k: add wmi support for pdev_set_quiet_mode
` [PATCH v2 6/8] ath10k: add thermal cooling device support
` [PATCH v2 7/8] ath10k: add wmi interface for pdev_get_temperature
` [PATCH v2 8/8] ath10k: add thermal sensor device support
[PATCH] ath10k: set phymode to 11b when NO_OFDM flag set
2014-12-23 15:25 UTC (2+ messages)
[PATCH 1/2] ath10k: fix low TX rates when IBSS and HT
2014-12-23 15:23 UTC (12+ messages)
` [PATCH 2/2] ath10k: send (re)assoc peer command when NSS changed
[PATCH v2 8/8] ath10k: add support to send delba
2014-12-22 9:11 UTC
ath10k: fw_stats not reporting peer_stats with 10.2
2014-12-18 13:00 UTC
[PATCH v2] mac80211: notify NSS changed when IBSS and HT
2014-12-17 10:47 UTC (2+ messages)
[PATCH] mac80211: notify NSS changed when IBSS and HT
2014-12-17 8:06 UTC (3+ messages)
[PATCH 0/5] ath10k: Add thermal mitigation support
2014-12-16 7:49 UTC (8+ messages)
` [PATCH 1/5] ath10k: add 10.2.4 firmware support
` [PATCH 2/5] ath10k: add wmi support for pdev_set_quiet_mode
` [PATCH 3/5] ath10k: add thermal cooling device support
` [PATCH 4/5] ath10k: add wmi interface for pdev_get_temperature
` [PATCH 5/5] ath10k: add thermal sensor device support
[PATCH 0/5] ath10k: a bunch of STA-related fixes
2014-12-16 7:27 UTC (14+ messages)
` [PATCH 1/5] ath10k: improve 11b coex
` [PATCH 2/5] ath10k: fix STA u-APSD
` [PATCH 3/5] ath10k: prevent invalid ps timeout config
` [PATCH 4/5] ath10k: enable per-vif sta powersave
` [PATCH 5/5] ath10k: advertise p2p dev support
` [PATCH v2 0/5] ath10k: a bunch of STA-related fixes
` [PATCH v2 1/5] ath10k: improve 11b coex
` [PATCH v2 2/5] ath10k: fix STA u-APSD
` [PATCH v2 3/5] ath10k: prevent invalid ps timeout config
` [PATCH v2 4/5] ath10k: enable per-vif sta powersave
` [PATCH v2 5/5] ath10k: advertise p2p dev support
[PATCH] ath10k: unregister and remove frag_threshold callback
2014-12-16 7:14 UTC (6+ messages)
[RFC] ath10k: allow to use HT rates when IBSS
2014-12-15 12:35 UTC
[PATCH 3/4] ath10k: Fix no-ack frame status
2014-12-15 8:27 UTC (5+ messages)
[HACK PATCH 0/4] ath10k: 802.3 frame format support
2014-12-08 17:17 UTC (5+ messages)
` [HACK PATCH 1/4] mac80211: rx
` [HACK PATCH 2/4] mac8011: tx
` [HACK PATCH 3/4] ath10k: rx
` [HACK PATCH 4/4] ath10k: tx
[PATCH v2 0/2] ath10k: NF calibration period debugfs file
2014-12-08 15:44 UTC (7+ messages)
` [PATCH v2 1/2] ath10k: add new pdev parameters for fw 10.2
` [PATCH v2 2/2] ath10k: add new wmi interface of NF cal period
[PATCH v4 0/8] ath10k: add support for new wmi-tlv backend
2014-12-08 15:41 UTC (16+ messages)
` [PATCH v4 1/8] ath10k: clean up error handling in ath10k_core_probe_fw()
` [PATCH v4 2/8] ath10k: create ath10k_core_init_features()
` [PATCH v4 3/8] ath10k: add ATH10K_FW_IE_WMI_OP_VERSION
` [PATCH v4 4/8] ath10k: set max_num_pending_tx in ath10k_core_init_firmware_features()
` [PATCH v4 5/8] ath10k: implement intermediate event args
` [PATCH v4 6/8] ath10k: introduce wmi ops
` [PATCH v4 7/8] ath10k: make some wmi functions public
` [PATCH v4 8/8] ath10k: implement wmi-tlv backend
[PATCH 1/3] ath10k: embed supported chip ids in hw_params
2014-12-08 15:35 UTC (5+ messages)
` [PATCH v2 1/3] ath10k: create a chip revision whielist
[PATCH v4 0/2] ath10k: device tree support
2014-12-08 15:33 UTC (2+ messages)
IBSS mode is now supported by CT firmware
2014-12-04 15:28 UTC (9+ messages)
[PATCH v3 0/7] ath10k: add support for new wmi-tlv backend
2014-12-03 6:32 UTC (17+ messages)
` [PATCH v3 1/7] ath10k: create ath10k_core_init_features()
` [PATCH v3 2/7] ath10k: add ATH10K_FW_IE_WMI_OP_VERSION
` [PATCH v3 3/7] ath10k: set max_num_pending_tx in ath10k_core_init_firmware_features()
` [PATCH v3 4/7] ath10k: implement intermediate event args
` [PATCH v3 5/7] ath10k: introduce wmi ops
` [PATCH v3 6/7] ath10k: make some wmi functions public
` [PATCH v3 7/7] ath10k: implement wmi-tlv backend
Pull request: ath 20141201
2014-12-02 10:10 UTC (3+ messages)
[PATCH 1/2] ath10k: add new pdev parameters for fw 10.2
2014-12-02 9:53 UTC (3+ messages)
` [PATCH 2/2] ath10k: add new wmi interface of NF cal period
[PATCH v2 0/7] ath10k: add support for new wmi-tlv backend
2014-12-01 14:19 UTC (4+ messages)
` [PATCH v2 7/7] ath10k: implement "
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox