Re: [PATCH v3] ath11k: Handle keepalive during WoWLAN suspend and resume

From: Kalle Valo <kvalo@kernel.org>
To: Baochen Qiang <quic_bqiang@quicinc.com>
Cc: <ath11k@lists.infradead.org>,  <linux-wireless@vger.kernel.org>
Subject: Re: [PATCH v3] ath11k: Handle keepalive during WoWLAN suspend and resume
Date: Tue, 10 May 2022 19:29:56 +0300	[thread overview]
Message-ID: <87wnet73ln.fsf@kernel.org> (raw)
In-Reply-To: <20220506012540.1579604-1-quic_bqiang@quicinc.com> (Baochen Qiang's message of "Fri, 6 May 2022 09:25:40 +0800")

Baochen Qiang <quic_bqiang@quicinc.com> writes:

> With WoWLAN enabled and after sleeping for a rather long time,
> we are seeing that with some APs, it is not able to wake up
> the STA though the correct wake up pattern has been configured.
> This is because the host doesn't send keepalive command to
> firmware, thus firmware will not send any packet to the AP and
> after a specific time the AP kicks out the STA.
>
> Fix this issue by enabling keepalive before going to suspend
> and disabling it after resume back.
>
> Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-01720.1-QCAHSPSWPL_V1_V2_SILICONZ_LITE-1
>
> Signed-off-by: Baochen Qiang <quic_bqiang@quicinc.com>

[...]

> --- a/drivers/net/wireless/ath/ath11k/wmi.h
> +++ b/drivers/net/wireless/ath/ath11k/wmi.h
> @@ -5907,6 +5907,45 @@ struct wmi_pdev_set_geo_table_cmd {
>  	u32 rsvd_len;
>  } __packed;
>  
> +struct wmi_sta_keepalive_cmd {
> +	u32 tlv_header;
> +	u32 vdev_id;
> +	u32 enabled;
> +	u32 method; /* WMI_STA_KEEPALIVE_METHOD_ */
> +	u32 interval; /* in seconds */
> +	/* NOTE: following this structure is the TLV for ARP Response:
> +	 * WMI_STA_KEEPALVE_ARP_RESPONSE arp_resp; <-- ARP response
> +	 */
> +} __packed;

I cleaned up the comments a bit.

> +enum wmi_sta_keepalive_method {
> +	WMI_STA_KEEPALIVE_METHOD_NULL_FRAME = 1, /* 802.11 NULL frame */
> +	WMI_STA_KEEPALIVE_METHOD_UNSOLICITED_ARP_RESPONSE = 2, /* ARP response */
> +	WMI_STA_KEEPALIVE_METHOD_ETHERNET_LOOPBACK = 3, /* ETHERNET LOOPBACK */
> +	WMI_STA_KEEPALIVE_METHOD_GRATUITOUS_ARP_REQUEST = 4, /* gratuitous ARP req */
> +	WMI_STA_KEEPALIVE_METHOD_MGMT_VENDOR_ACTION = 5, /* vendor action frame */
> +};

The comments are not really bringing any extra value from the actual
names so I just removed them.

-- 
https://patchwork.kernel.org/project/linux-wireless/list/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches

-- 
ath11k mailing list
ath11k@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/ath11k