[PATCH v5 5/8] ath11k: set psc channel flag when sending channel list to firmware.

Pradeep Kumar Chitrapu
2020-06-03T00:17:48Z

If 6 ghz channel is a Preferred Scanning Channel(PSC), mark
the channel flag accordingly when updating channel list to firmware.
This will be used when making scanning decision in 6GHz channels.

Signed-off-by: Pradeep Kumar Chitrapu <pradeepc@codeaurora.org>
---
drivers/net/wireless/ath/ath11k/reg.c | 4 ++++
drivers/net/wireless/ath/ath11k/wmi.h | 3 ++-
2 files changed, 6 insertions(+), 1 deletion(-)

diff --git a/drivers/net/wireless/ath/ath11k/reg.c b/drivers/net/wireless/ath/ath11k/reg.c
index 453aa9c06969..7c9dc91cc48a 100644
--- a/drivers/net/wireless/ath/ath11k/reg.c
+++ b/drivers/net/wireless/ath/ath11k/reg.c
@@ -161,6 +161,10 @@ int ath11k_reg_update_chan_list(struct ath11k *ar)
else
ch->phy_mode = MODE_11A;

+ if (channel->band == NL80211_BAND_6GHZ &&
+ cfg80211_channel_is_psc(channel))
+ ch->psc_channel = true;
+
ath11k_dbg(ar->ab, ATH11K_DBG_WMI,
"mac channel [%d/%d] freq %d maxpower %d regpower %d antenna %d mode %d\n",
i, params->nallchans,
diff --git a/drivers/net/wireless/ath/ath11k/wmi.h b/drivers/net/wireless/ath/ath11k/wmi.h
index fd82cff7537b..76c2da2c5db7 100644
--- a/drivers/net/wireless/ath/ath11k/wmi.h
+++ b/drivers/net/wireless/ath/ath11k/wmi.h
@@ -2520,7 +2520,8 @@ struct channel_param {
allow_ht:1,
allow_vht:1,
allow_he:1,
- set_agile:1;
+ set_agile:1,
+ psc_channel:1;
u32 phy_mode;
u32 cfreq1;
u32 cfreq2;
--
2.17.1