Re: [PATCH 5/8] wifi: ath12k: add reo queue lookup table for ML peers

Jeff Johnson
2024-11-06T16:33:37Z

On 11/6/2024 6:26 AM, Kalle Valo wrote:
> From: Rameshkumar Sundaram <quic_ramess@quicinc.com>
>
> Currently reoqueue tid setup uses lookup table (LUT) during peer association,
> but for ML peer there will be multiple link peers (belonging to different
> underlying firmware) affiliated to each other. Hence the reo queue should be
> setup only on one of the links which is the primary link.
>
> Add changes to create separate ML reo queue lookup table for ML peers and use
> the same while setting up rx tid for ML peer's primary link. For ML peers use
> ml_peer_id instead of peer_id to setup/lookup the reo queue entry in the LUT.
>
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.3.1-00173-QCAHKSWPL_SILICONZ-1
> Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3
>
> Signed-off-by: Rameshkumar Sundaram <quic_ramess@quicinc.com>
> Signed-off-by: Kalle Valo <quic_kvalo@quicinc.com>
Acked-by: Jeff Johnson <quic_jjohnson@quicinc.com>