Re: [PATCH ath-next] wifi: ath12k: Enable monitor mode support on IPQ5332

[Vasanthakumar Thiagarajan <vasanthakumar.thiagarajan@oss.qualcomm.com>]

On 2/27/2026 9:03 AM, Aaradhana Sahu wrote:
> Currently, rxdma1_enable and supports_monitor are set to false in
> IPQ5332 hardware parameters, which skips monitor ring configuration
> and removes NL80211_IFTYPE_MONITOR from the supported interface modes.
> 
> Set rxdma1_enable and supports_monitor to true so that monitor rings are
> configured and monitor mode is enabled on IPQ5332.
> 
> Tested-on: IPQ5332 hw1.0 AHB WLAN.WBE.1.7-00587-QCAHKSWPL_SILICONZ-1
> 
> Signed-off-by: Aaradhana Sahu <aaradhana.sahu@oss.qualcomm.com>
> ---
>   drivers/net/wireless/ath/ath12k/wifi7/hw.c | 4 ++--
>   1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/net/wireless/ath/ath12k/wifi7/hw.c b/drivers/net/wireless/ath/ath12k/wifi7/hw.c
> index df045ddf42da..27acdfc35459 100644
> --- a/drivers/net/wireless/ath/ath12k/wifi7/hw.c
> +++ b/drivers/net/wireless/ath/ath12k/wifi7/hw.c
> @@ -617,7 +617,7 @@ static const struct ath12k_hw_params ath12k_wifi7_hw_params[] = {
>   			ath12k_wifi7_target_service_to_ce_map_wlan_ipq5332,
>   		.svc_to_ce_map_len = 18,
>   
> -		.rxdma1_enable = false,
> +		.rxdma1_enable = true,
>   		.num_rxdma_per_pdev = 1,
>   		.num_rxdma_dst_ring = 0,
>   		.rx_mac_buf_ring = false,
> @@ -626,7 +626,7 @@ static const struct ath12k_hw_params ath12k_wifi7_hw_params[] = {
>   		.interface_modes = BIT(NL80211_IFTYPE_STATION) |
>   				   BIT(NL80211_IFTYPE_AP) |
>   				   BIT(NL80211_IFTYPE_MESH_POINT),
> -		.supports_monitor = false,
> +		.supports_monitor = true,
>   
>   		.idle_ps = false,
>   		.download_calib = true,

Reviewed-by: Vasanthakumar Thiagarajan <vasanthakumar.thiagarajan@oss.qualcomm.com>