Re: [PATCH 0/7] wifi: ath12k: Add monitor interface support on QCN9274

["Nicolas Escande" <nico.escande@gmail.com>]

On Fri Jan 17, 2025 at 5:37 AM CET, Karthikeyan Periyasamy wrote:
> On 1/15/2025 11:25 PM, Nicolas Escande wrote:
> > On Tue Jan 7, 2025 at 3:10 AM CET, Karthikeyan Periyasamy wrote:
[...] 
> > I applied it on top of ath-pending-202501150104 + the "ath12k: Add peer extended
> > Rx statistics debugfs support" and now 'iw dev wlan0 station dump' shows me
> > that the RSSI value seems to not be updated anymore after I stop a monitor
> > interface on the same phy.
> > 
> > Steps to reproduce:
> > iw phy phy0 interface add mon0 type monitor
> > ip link set mon0 up
> > # then just for 1 sec but it might not be usefull at all
> > tcpdump -nepi mon0
> > ip link set mon0 down
> > watch -n1 iw dev wlan0 station dump
> > # 'signal' seems to not be updating anymore, maybe some other fields too ?
> > 
>
> Not able to find the wlan0 interface details from the above steps ?

Arf maybe I wasn't clear, my bad.

I have a running AP on wlan0. I constantly monitor connected stations infos
using 'iw dev wlan0 station dump' on the side in another terminal, and then I
add a monitor interface with the above steps, and thats when I see that the
stations connected to my AP have frozen values in station dump.

I suspect that ath12k_dp_tx_htt_rx_monitor_mode_ring_config() should reset the
rx filters to ath12k_mac_mon_status_filter_default when disabling monitor. But
I'm not so sure, you guys know better.