[ath9k-devel] [PATCH] ath9k_htc: Do not support PowerSave by default

[Oleksij Rempel <linux@rempel-privat.de>]

It is a copy/paste of patch provided by Sujith for ath9k.

"Even though we make sure PowerSave is not enabled by default
by disabling the flag, WIPHY_FLAG_PS_ON_BY_DEFAULT on init,
PS could be enabled by userspace based on various factors
like battery usage etc. Since PS in ath9k is just broken
and has been untested for years, remove support for it, but
allow a user to explicitly enable it using a module parameter."

Cc: stable at vger.kernel.org
Signed-off-by: Oleksij Rempel <linux@rempel-privat.de>
---
 drivers/net/wireless/ath/ath9k/htc_drv_init.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/net/wireless/ath/ath9k/htc_drv_init.c b/drivers/net/wireless/ath/ath9k/htc_drv_init.c
index 9db8aef..8d0b9bc 100644
--- a/drivers/net/wireless/ath/ath9k/htc_drv_init.c
+++ b/drivers/net/wireless/ath/ath9k/htc_drv_init.c
@@ -34,6 +34,10 @@ static int ath9k_htc_btcoex_enable;
 module_param_named(btcoex_enable, ath9k_htc_btcoex_enable, int, 0444);
 MODULE_PARM_DESC(btcoex_enable, "Enable wifi-BT coexistence");
 
+static int ath9k_ps_enable;
+module_param_named(ps_enable, ath9k_ps_enable, int, 0444);
+MODULE_PARM_DESC(ps_enable, "Enable WLAN PowerSave");
+
 #define CHAN2G(_freq, _idx)  { \
 	.center_freq = (_freq), \
 	.hw_value = (_idx), \
@@ -726,12 +730,14 @@ static void ath9k_set_hw_capab(struct ath9k_htc_priv *priv,
 		IEEE80211_HW_SPECTRUM_MGMT |
 		IEEE80211_HW_HAS_RATE_CONTROL |
 		IEEE80211_HW_RX_INCLUDES_FCS |
-		IEEE80211_HW_SUPPORTS_PS |
 		IEEE80211_HW_PS_NULLFUNC_STACK |
 		IEEE80211_HW_REPORTS_TX_ACK_STATUS |
 		IEEE80211_HW_MFP_CAPABLE |
 		IEEE80211_HW_HOST_BROADCAST_PS_BUFFERING;
 
+	if (ath9k_ps_enable)
+		hw->flags |= IEEE80211_HW_SUPPORTS_PS;
+
 	hw->wiphy->interface_modes =
 		BIT(NL80211_IFTYPE_STATION) |
 		BIT(NL80211_IFTYPE_ADHOC) |
-- 
1.8.5.3