autofs.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Christof Koehler <christof.koehler@bccms.uni-bremen.de>
To: Ian Kent <raven@themaw.net>
Cc: autofs@vger.kernel.org
Subject: Re: autofs reverts to IPv4 for multi-homed IPv6 server ?
Date: Thu, 28 Apr 2016 13:26:48 +0200	[thread overview]
Message-ID: <20160428112648.GS30271@bccms.uni-bremen.de> (raw)
In-Reply-To: <1461840658.3063.18.camel@themaw.net>

Hello,

On Thu, Apr 28, 2016 at 06:50:58PM +0800, Ian Kent wrote:
> On Thu, 2016-04-28 at 11:10 +0200, Christof Koehler wrote:
> 
> Sounds like I'll need to actually have a look at that RFC before doing
> anything, ;)
These might be nicer reads:
http://biplane.com.au/blog/?p=22
http://biplane.com.au/blog/?p=30

Please note that the actual "ip addrlabel" output on a pristine 16.04
is 
prefix ::1/128 label 0 
prefix ::/96 label 3 
prefix ::ffff:0.0.0.0/96 label 4 
prefix 2001::/32 label 6 
prefix 2001:10::/28 label 7 
prefix 3ffe::/16 label 12 
prefix 2002::/16 label 2 
prefix fec0::/10 label 11 
prefix fc00::/7 label 5 
prefix ::/0 label 1
so that catches ULAs in the fc00::/7 already with a label separating
them. I additional add
prefix 2001:638:708:1261:2000::/96 label 99 
prefix 2001:638:708:1261:1000::/96 label 99
but that should not matter.

> > However, ping times (response times) on ethernet effectively show
> > random variations, sometimes in the millisecond range.
> 
> True but the worst case is you end up with a trivial load balancing
> effect.

If addresses are equivalent that is a desirable effect. My goal however
was to distinguish between GUA and ULA relying on the RFC for selection
to avoid headaches. I will have to rethink this for sure.

> Say, for example, you had multiple distinct interfaces on a machine to
> increase available throughput (believe it or not I've seen it done) then
> this sort of load balancing could be beneficial.

Yes, been there, done that; but I would consider that something no longer needed 
in this enlightened age:
https://help.ubuntu.com/community/UbuntuBonding#Descriptions_of_bonding_modes
Especially Mode 4. But I think you know them :-)


> 
> Mmm .. you should be able to put addresses in the map.
I will try again to make sure.

> 
> The ppa is done, to the extent that I wanted too, so check it out.
> Have a look at https://launchpad.net/~raven-au.
> 
Thank you, I will try and report back.


Best Regards

Christof

-- 
Dr. rer. nat. Christof Köhler       email: c.koehler@bccms.uni-bremen.de
Universitaet Bremen/ BCCMS          phone:  +49-(0)421-218-62334
Am Fallturm 1/ TAB/ Raum 3.12       fax: +49-(0)421-218-62770
28359 Bremen  

PGP: http://www.bccms.uni-bremen.de/cms/people/c_koehler/
--
To unsubscribe from this list: send the line "unsubscribe autofs" in

  reply	other threads:[~2016-04-28 11:26 UTC|newest]

Thread overview: 49+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2016-04-07 14:19 autofs reverts to IPv4 for multi-homed IPv6 server ? Christof Koehler
2016-04-08  4:46 ` Ian Kent
2016-04-08 10:10   ` Ian Kent
2016-04-08 10:14     ` Ian Kent
2016-04-08 12:25     ` Christof Koehler
2016-04-08 14:29       ` Christof Koehler
2016-04-08 15:32         ` Christof Koehler
2016-04-10  2:09           ` Ian Kent
2016-04-08 16:12         ` Christof Koehler
2016-04-08 16:15           ` Christof Koehler
2016-04-10  2:17             ` Ian Kent
2016-04-10  2:14           ` Ian Kent
2016-04-09  1:42         ` Ian Kent
2016-04-09  9:56           ` Christof Koehler
2016-04-10  2:29             ` Ian Kent
2016-04-25  4:40             ` Ian Kent
2016-04-25 15:06               ` Christof Koehler
2016-04-26  1:06                 ` Ian Kent
2016-04-26  9:53                   ` Ian Kent
2016-04-26 15:27                     ` Christof Koehler
2016-04-27  1:54                       ` Ian Kent
2016-04-27  2:27                         ` Ian Kent
2016-04-27 16:52                         ` Christof Koehler
2016-04-28  2:56                           ` Ian Kent
2016-04-28  3:21                             ` Ian Kent
2016-04-28  9:12                               ` Christof Koehler
2016-04-28  9:10                             ` Christof Koehler
2016-04-28 10:50                               ` Ian Kent
2016-04-28 11:26                                 ` Christof Koehler [this message]
2016-04-28 12:40                                   ` Christof Koehler
2016-04-29  1:54                                   ` Ian Kent
2016-04-29 14:10                                     ` Christof Koehler
2016-04-29 14:42                                       ` Christof Koehler
2016-04-30  3:21                                       ` Ian Kent
2016-04-30 11:36                                         ` Christof Koehler
2016-04-30 15:15                                           ` Christof Koehler
2016-04-30 15:16                                           ` Christof Koehler
2016-05-02  6:01                                           ` Ian Kent
2016-05-02 16:08                                             ` Christof Koehler
2016-05-03  7:58                                               ` Ian Kent
2016-05-03 15:13                                                 ` Christof Koehler
2016-05-04  7:20                                                   ` Ian Kent
2016-05-04 12:38                                                     ` Christof Koehler
2016-04-09  1:35       ` Ian Kent
2016-04-11  2:42     ` Ian Kent
2016-04-11 16:32       ` Christof Koehler
2016-04-11 16:35         ` Christof Koehler
2016-04-12  1:07           ` Ian Kent
2016-04-08 11:47   ` Christof Koehler

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20160428112648.GS30271@bccms.uni-bremen.de \
    --to=christof.koehler@bccms.uni-bremen.de \
    --cc=autofs@vger.kernel.org \
    --cc=raven@themaw.net \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).