Re: Batman-adv packet retranslation

[Marek Lindner <mareklindner@neomailbox.ch>]

[-- Attachment #1: Type: text/plain, Size: 1043 bytes --]

On Monday, 25 May 2020 16:59:23 CEST Alexey Ermakov wrote:
> Below I provide ethernet MAC addresses, tables with throughput overrid
> to 100kbit/s and tables without output override.
> Note that in case without override batman detects throughput about
> 100mbit/s. This is not quiet correct, because as I say before, nodes
> connects to modems and throughput from node to modem is 100mbit/s, but
> actual speed of modem is 145 kbit/sб therefore I should set throughput
> override

I am surprised you still are configuring a throughput override of 100kbit/s. 
What's the idea behind this configuration ?
As explained before, by configuring this low throughput value you are 
preventing any multi-hop route detection. Is that intended ?


> Tables without throughput override:

Since the throughput is auto-detected in your setup why are you configuring a 
manual throughput override ?

Now that we see the tables where do we see what issue ? What is not working as 
per your expectation ?

Kind regards,
Marek Lindner

[-- Attachment #2: This is a digitally signed message part. --]
[-- Type: application/pgp-signature, Size: 488 bytes --]