On Donnerstag, 14. Dezember 2017 12:20:48 CET Carlito Nueno wrote:
> Hi all,
> 
> I have nodes A, B, C.
> On all nodes, wifi and lan are bridged. Also, they are all connected via mesh.
> 
>                                         |---> node B
> ethernet <--> Node A <-- |
>                                         | ---> node C
> 
> Node A is the exit node - connected via ethernet cable and node B and
> node C are connected to A via mesh.
>
> So, when I connect node C via ethernet, does it start using ethernet
> as backhaul or still keeping mesh.
[...]

Sorry, this is not a batman-adv question. And it highly depends on your 
configuration. For example, the bat0 interface doesnt seem to be in the 
bridge. So I have to assume that you use routing - and thus you have to check 
your metric settings for each IP(v6) route.

And if everything is in a bridge then you have to check your bridge cost
(and STP, ...) configurations.

Kind regards,
	Sven