Re: [B.A.T.M.A.N.] 0.3 alpha (today revison)

[Axel Neumann <axel@open-mesh.net>]

Hello,

On Montag 24 September 2007, Michael Burmeister-Brown wrote:
> Marek,
>
> I hate to bother you but you were so responsive before...
>
> Antonio just put up a post.  We are both seeing the same problem -
> computers associated with repeaters on 0.3 (MIPS) can't browse.  But ssh
> into that node and do a wget and it works great!.  If we just replace
> 0.3 with 0.2 all works again.

So you want to use the batman-clients as APs for usual 802.11-managed-mode 
clients.
If I understand you right, then you prbably need to do network address 
translation (NAT) or MASQUERADEing on the bat0 interfaces on the batman 
clients.
And of course a second time on the batman-GW.

>
> Also, I am tracking memory and see it dropping steadily on the nodes
> (500k in about 12 hours).  This didn't happen with 0.2 and that is all
> that has changed.
Thats interesting, sounds like a memory leak, because in the lates setups i 
tested the memory consumption was constantly 3.1 percent (even after hours). 
using dynamically compiled mipsel binaries and up to 20 nodes .
Can you send the output from top right after the start, after a few minutes 
and after a few hours. And the output of debug-level -5 (hope its compiled 
in)

ciao,
axel