Re: [B.A.T.M.A.N.] default routes not set

leongmzlist
2009-04-09T07:50:31Z

Turns out I didn't have the batgat kernel module loaded; now I can
connect to the net. However, the default gw is still not
automatically set on the repeater

mike

At 12:23 AM 4/9/2009, leongmzlist wrote:
>Hi,
>new at batman. I've got the following done:
>
>1. got an airlink ar430w and wrt54gl to ping each other over ad-hoc network
>2. setup br-lan:0 on each router. ar430w has is 192.168.100.1;
>wrt54gl is 192.168.100.2
>3. was able to ping each other via br-lan:0 IP
>4. using openwrt 8.09 on both routers.
>
>The wrt54gl got the wan/internet link up. I started "batmand -g
>1mbit/128kbit br-lan:0"
>the ar430w doesn't have internet; I started "batmand -r 3 -d 3 br-lan:0"
>
>got this on the ar430w logs:
>
>Interface activated: br-lan:0
>Using interface br-lan:0 with address 192.168.100.1 and broadcast
>address 192.168.100.255
>B.A.T.M.A.N. 0.3.1 rv1206 (compatibility version 5)
>Adding throw route to 127.0.0.0/8 via 0.0.0.0 (table 68 - lo)
>Adding throw route to 192.168.1.0/24 via 0.0.0.0 (table 68 - br-lan)
>Adding throw route to 192.168.100.0/24 via 0.0.0.0 (table 68 - br-lan:0)
>debug level: 3
>routing class: 3
>Adding route to 192.168.100.2 via 0.0.0.0 (table 66 - br-lan:0)
>Found new gateway 192.168.100.2 -> class: 32 - 1024KBit/128KBit
>Adding default route to 192.168.100.2 (gw_flags: 32, tq: 217, gw_product: 0)
>Gateway client - got IP (169.254.0.1) from gateway: 192.168.100.2
>Adding default route via gate0 (table 68)
>
>
>When I run route -n on the ar430w, there's no default route set. I
>manually ran:
>route add default gw 169.254.0.1
>
>Next I tried to ping the outside world on the ar430w but it gets no
>where. Any ideas?
>
>thx
>mike