From: Anton Gillert <anton.gillert@fokus.fraunhofer.de>
To: b.a.t.m.a.n@open-mesh.net
Subject: [B.A.T.M.A.N.] Batman problem with tun0
Date: Wed, 04 Jul 2007 16:33:55 +0200 [thread overview]
Message-ID: <468BAFD3.6060700@fokus.fraunhofer.de> (raw)
I have following problem:
I have two Asus wl500gp router, each with atheros(Atheros 5212)
wlancards, running kamikaze 7.06; kernel ver.:2.6.19.2. and B.A.T.M.A.N.
0.2 rv451 (compability version 3)
one of them has access to the internet.
The one who has no internet connection, doesn't set a default route to
the one who has. It only sets this routes:
Destination Gateway Genmask Flags Metric Ref Use
Iface
192.168.33.23 0.0.0.0 255.255.255.255 UH 0 0 0
ath0
0.0.0.0 0.0.0.0 0.0.0.0 U
0 0 0 tun0
how can I fix it, or what did I wrong? here my are settings
On the router with the internet connection:
NIC:
ath0 IEEE 802.11g ESSID:"muh" Nickname:""
Mode:Ad-Hoc Frequency:2.412 GHz Cell: 02:0B:6B:4E:17:DA
Bit Rate:0 kb/s Tx-Power:16 dBm Sensitivity=0/3
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=27/94 Signal level=-68 dBm Noise level=-95 dBm
Rx invalid nwid:621 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
ath0 Link encap:Ethernet HWaddr 00:0B:6B:4E:17:DA
inet addr:192.168.33.23 Bcast:192.168.255.255 Mask:255.255.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1759 errors:0 dropped:0 overruns:0 frame:0
TX packets:1720 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:91520 (89.3 KiB) TX bytes:89328 (87.2 KiB)
batmand:
batmand -g 11 -r 0 ath0
batmand -c -d 1
Originator Router (#/128): Potential routers...
[B.A.T.M.A.N. 0.2 rv451, MainIF/IP: ath0 192.168.33.23, UT: 0d 0h16m]
192.168.33.27 192.168.33.27 (128): 192.168.33.27 (128)
route:
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
192.168.33.27 0.0.0.0 255.255.255.255 UH 0 0 0
ath0
10.147.112.0 0.0.0.0 255.255.255.128 U 0 0 0
eth0.1
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0
br-lan
192.168.0.0 0.0.0.0 255.255.0.0 U 0 0 0
ath0
0.0.0.0 10.147.112.1 0.0.0.0 UG 0 0 0
eth0.1
configuration of the router without internet connection:
NIC:
ath0 IEEE 802.11g ESSID:"muh" Nickname:""
Mode:Ad-Hoc Frequency:2.412 GHz Cell: 02:0B:6B:4E:17:DA
Bit Rate:0 kb/s Tx-Power:16 dBm Sensitivity=0/3
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=62/94 Signal level=-33 dBm Noise level=-95 dBm
Rx invalid nwid:197859 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
ath0 Link encap:Ethernet HWaddr 00:0B:6B:4E:17:53
inet addr:192.168.33.27 Bcast:192.168.255.255 Mask:255.255.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:886366 errors:0 dropped:0 overruns:0 frame:0
TX packets:887894 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:46036433 (43.9 MiB) TX bytes:46196970 (44.0 MiB)
# was set by batmand
tun0 Link encap:UNSPEC HWaddr
00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00
inet addr:192.168.33.27 P-t-P:192.168.33.27 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1472 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:500
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
batmand:
batmand -r 1 ath0
batmand -c -d 1
Originator Router (#/128): Potential routers...
[B.A.T.M.A.N. 0.2 rv451, MainIF/IP: ath0 192.168.33.27, UT: 5d 0h28m]
192.168.33.23 192.168.33.23 (128): 192.168.33.23 (128)
batmanad -c -d 2
Gateway Router (#/128)
=> 192.168.33.23 192.168.33.23 (128), gw_class 11 - >6 MBit,
reliability: 0
route:
Destination Gateway Genmask Flags Metric Ref Use
Iface
192.168.33.23 0.0.0.0 255.255.255.255 UH 0 0 0
ath0
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0
br-lan
192.168.0.0 0.0.0.0 255.255.0.0 U 0 0 0
ath0
0.0.0.0 0.0.0.0 0.0.0.0 U 0 0 0
tun0
next reply other threads:[~2007-07-04 14:33 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2007-07-04 14:33 Anton Gillert [this message]
2007-07-04 15:07 ` [B.A.T.M.A.N.] Batman problem with tun0 Marek Lindner
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=468BAFD3.6060700@fokus.fraunhofer.de \
--to=anton.gillert@fokus.fraunhofer.de \
--cc=b.a.t.m.a.n@open-mesh.net \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox