This is available only in openwrt based systems.
It is in /etc/config/

There is no /etc/init.d for batman-adv. it is started along the network
setup.

On 06/15/2014 09:49 AM, michael.holcman1@free.fr wrote:
> Hello,
> Do you know how to auto run batman-adv, because, i have no answer where i write:/etc/init.d enable ?
> 
> Where i can located the configure fils as following ?
> 
> 
> config 'mesh' 'bat0'
> 	option 'interface' 'wlan0' 'bride'
> 	option 'aggregated_ogms'
> 	option 'ap_isolation'
> 	option 'bonding'
> 	option 'fragmentation'
> 	option 'gw_bandwidth'
> 	option 'gw_mode'
> 	option 'gw_sel_class'
> 	option 'log_level' 'all'
> 	option 'orig_interval' '500'
> 	option 'vis_mode'
> 	option 'bridge_loop_avoidance' '1'
> 	option 'distributed_arp_table'
> 	option 'network_coding'
> 	option 'hop_penalty'
> 
> # yet another batX instance
> # config 'mesh' 'bat5'
> #	option 'interfaces' 'second_mesh'
>