[Buildroot] [PATCH v2 2/2] arch: tidy up binary formats config

["Guido Martínez" <guido@vanguardiasur.com.ar>]

On Wed, Jun 03, 2015 at 10:48:43PM +0200, Arnout Vandecappelle wrote:
> On 06/03/15 16:12, Guido Mart?nez wrote:
> > @@ -272,13 +276,13 @@ config BR2_BINFMT_SUPPORTS_SHARED
> >  # Set up target binary format
> >  choice
> >  	prompt "Target Binary Format"
> > -	default BR2_BINFMT_ELF if !(BR2_bfin || BR2_m68k)
> > -	default BR2_BINFMT_FDPIC if BR2_bfin
> > -	default BR2_BINFMT_FLAT if BR2_m68k
> > +	default BR2_BINFMT_ELF		if BR2_USE_MMU
> > +	default BR2_BINFMT_FDPIC	if BR2_ARCH_HAS_FDPIC_SUPPORT
> > +	default BR2_BINFMT_FLAT		if !BR2_USE_MMU
> 
>  I think this should either be without condition at all, or with a condition
> that matches the previous ones, i.e. if !BR2_USE_MMU && !BR2_ARCH_HAS_FDPIC_SUPPORT.
Ugh, right, either fully use the short circuiting or not at all. I'd say
we use no conditions on FLAT.

>  Also we normally don't do any vertical alignment at all, so just put a single
> space instead of tabs.
OK, agreed.

Would it be better for me to resend or is this simple enough to be fixed
up when commiting?

Thanks!

-- 
Guido Mart?nez, VanguardiaSur
www.vanguardiasur.com.ar