From mboxrd@z Thu Jan 1 00:00:00 1970 From: Gary Bisson Date: Wed, 2 Nov 2016 10:17:43 +0100 Subject: [Buildroot] [PATCH] board/boundarydevices: remove u-boot from genimage.cfg Message-ID: <20161102091743.8494-1-gary.bisson@boundarydevices.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: buildroot@busybox.net Adding a comment to explain how to update the bootloader since it is located in NOR flash memory. Signed-off-by: Gary Bisson --- Hi, Just realized that our genimage.cfg can be confusing since it copies the u-boot binary although the BootROM will always boot from NOR. Regards, Gary --- board/boundarydevices/common/genimage.cfg | 14 ++++++++------ 1 file changed, 8 insertions(+), 6 deletions(-) diff --git a/board/boundarydevices/common/genimage.cfg b/board/boundarydevices/common/genimage.cfg index 7a5e71e..a383fb7 100644 --- a/board/boundarydevices/common/genimage.cfg +++ b/board/boundarydevices/common/genimage.cfg @@ -1,13 +1,15 @@ +# Minimal SD card image for Boundary Devices platforms +# +# It does not need a boot section for a bootloader since it is booted +# from its NOR flash memory. +# +# To update the bootloader, execute the following from U-Boot prompt: +# => run upgradeu + image sdcard.img { hdimage { } - partition u-boot { - in-partition-table = "no" - image = "u-boot.imx" - offset = 1024 - } - partition rootfs { partition-type = 0x83 image = "rootfs.ext4" -- 2.9.3