From: Jagan Teki <jagan@amarulasolutions.com>
To: buildroot@busybox.net
Subject: [Buildroot] [PATCH] board: orangepi: zero-plus2: bump linux to v4.16
Date: Tue, 5 Jun 2018 15:06:32 +0530 [thread overview]
Message-ID: <20180605093632.26724-1-jagan@amarulasolutions.com> (raw)
Bump linux as well headers to v4.16 version, this
eventually drop the wifi patch since it has been
merged to Linux v4.16.
Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
---
...64-dts-orange-pi-zero-plus2-enable-ap6212.patch | 73 ----------------------
configs/orangepi_zero_plus2_defconfig | 5 +-
2 files changed, 2 insertions(+), 76 deletions(-)
delete mode 100644 board/orangepi/orangepi-zero-plus2/patches/linux/linux-0001-arm64-dts-orange-pi-zero-plus2-enable-ap6212.patch
diff --git a/board/orangepi/orangepi-zero-plus2/patches/linux/linux-0001-arm64-dts-orange-pi-zero-plus2-enable-ap6212.patch b/board/orangepi/orangepi-zero-plus2/patches/linux/linux-0001-arm64-dts-orange-pi-zero-plus2-enable-ap6212.patch
deleted file mode 100644
index 282e2171f2..0000000000
--- a/board/orangepi/orangepi-zero-plus2/patches/linux/linux-0001-arm64-dts-orange-pi-zero-plus2-enable-ap6212.patch
+++ /dev/null
@@ -1,73 +0,0 @@
-From: Sergey Matyukevich <geomatsi@gmail.com>
-Date: Sun, 11 Feb 2018 16:21:43 +0300
-Subject: [PATCH] arm64: dts: orange-pi-zero-plus2: enable AP6212a WiFi/BT combo
-
-Enable AP6212a WiFi/BT combo chip on orange-pi-zero-plus2 board:
-- WiFi SDIO interface is connected to MMC1
-- WiFi REG_ON pin connected to gpio PA9: attach to mmc-pwrseq
-- WiFi HOST_WAKE pin connected to gpio PL7
-- BT is connected to UART1
-
-Signed-off-by: Sergey Matyukevich <geomatsi@gmail.com>
-Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>
----
- .../allwinner/sun50i-h5-orangepi-zero-plus2.dts | 32 ++++++++++++++++++++++
- 1 file changed, 32 insertions(+)
-
-diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus2.dts b/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus2.dts
-index a42fd79a62a3..d415b7b67cce 100644
---- a/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus2.dts
-+++ b/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus2.dts
-@@ -64,6 +64,13 @@
- regulator-min-microvolt = <3300000>;
- regulator-max-microvolt = <3300000>;
- };
-+
-+ wifi_pwrseq: wifi_pwrseq {
-+ compatible = "mmc-pwrseq-simple";
-+ pinctrl-names = "default";
-+ reset-gpios = <&pio 0 9 GPIO_ACTIVE_LOW>; /* PA9 */
-+ post-power-on-delay-ms = <200>;
-+ };
- };
-
- &mmc0 {
-@@ -75,6 +82,25 @@
- status = "okay";
- };
-
-+&mmc1 {
-+ pinctrl-names = "default";
-+ pinctrl-0 = <&mmc1_pins_a>;
-+ vmmc-supply = <®_vcc3v3>;
-+ vqmmc-supply = <®_vcc3v3>;
-+ mmc-pwrseq = <&wifi_pwrseq>;
-+ bus-width = <4>;
-+ non-removable;
-+ status = "okay";
-+
-+ brcmf: wifi at 1 {
-+ reg = <1>;
-+ compatible = "brcm,bcm4329-fmac";
-+ interrupt-parent = <&r_pio>;
-+ interrupts = <0 7 IRQ_TYPE_LEVEL_LOW>; /* PL7 */
-+ interrupt-names = "host-wake";
-+ };
-+};
-+
- &mmc2 {
- pinctrl-names = "default";
- pinctrl-0 = <&mmc2_8bit_pins>;
-@@ -90,3 +116,9 @@
- pinctrl-0 = <&uart0_pins_a>;
- status = "okay";
- };
-+
-+&uart1 {
-+ pinctrl-names = "default";
-+ pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
-+ status = "okay";
-+};
---
-2.16.1
-
diff --git a/configs/orangepi_zero_plus2_defconfig b/configs/orangepi_zero_plus2_defconfig
index 5ca6cf0fe2..8c83b3acd1 100644
--- a/configs/orangepi_zero_plus2_defconfig
+++ b/configs/orangepi_zero_plus2_defconfig
@@ -2,9 +2,8 @@ BR2_aarch64=y
BR2_cortex_a53=y
BR2_ARM_FPU_VFPV4=y
-BR2_PACKAGE_HOST_LINUX_HEADERS_CUSTOM_4_15=y
+BR2_PACKAGE_HOST_LINUX_HEADERS_CUSTOM_4_16=y
BR2_ROOTFS_DEVICE_CREATION_DYNAMIC_MDEV=y
-BR2_GLOBAL_PATCH_DIR="board/orangepi/orangepi-zero-plus2/patches"
BR2_ROOTFS_OVERLAY="board/orangepi/orangepi-zero-plus2/rootfs_overlay"
# Firmware
@@ -33,7 +32,7 @@ BR2_TARGET_UBOOT_BOOT_SCRIPT_SOURCE="board/orangepi/orangepi-zero-plus2/boot.cmd
# Kernel
BR2_LINUX_KERNEL=y
BR2_LINUX_KERNEL_CUSTOM_VERSION=y
-BR2_LINUX_KERNEL_CUSTOM_VERSION_VALUE="4.15.2"
+BR2_LINUX_KERNEL_CUSTOM_VERSION_VALUE="4.16"
BR2_LINUX_KERNEL_USE_ARCH_DEFAULT_CONFIG=y
BR2_LINUX_KERNEL_DTS_SUPPORT=y
BR2_LINUX_KERNEL_INTREE_DTS_NAME="allwinner/sun50i-h5-orangepi-zero-plus2"
--
2.14.3
next reply other threads:[~2018-06-05 9:36 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-06-05 9:36 Jagan Teki [this message]
2018-06-05 16:48 ` [Buildroot] [PATCH] board: orangepi: zero-plus2: bump linux to v4.16 Thomas Petazzoni
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20180605093632.26724-1-jagan@amarulasolutions.com \
--to=jagan@amarulasolutions.com \
--cc=buildroot@busybox.net \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox