[Buildroot] [PATCH 3/4] configs: bpi-m64: Use Mainline ARM ATF

[Thomas Petazzoni <thomas.petazzoni@bootlin.com>]

Hello,

On Mon, 3 Sep 2018 10:06:40 +0100, Andre Przywara wrote:
> Hi,
> 
> On 03/09/18 09:26, Jagan Teki wrote:
> > Use Mainline ARM ATF for bananapi-m64 board instead
> > Andre's github.  
> 
> Have you tested it? The mainline ATF is not feature-complete yet, so in
> comparison to the old port you are missing the PMIC setup. This breaks
> power off and, more importantly, Ethernet support in U-Boot. I have some
> code to introduce proper (even better) PMIC support, just didn't come
> around to clean it up and post it.
> Meanwhile I would suggest to stick to the old port - actually this was
> the reason I didn't advertise this more widely yet.

So I guess this comment also applied to the Orangepi One Plus patch
(PATCH 2/4) in this series, since it also uses mainline ATF:

+# Firmware
+BR2_TARGET_ARM_TRUSTED_FIRMWARE=y
+BR2_TARGET_ARM_TRUSTED_FIRMWARE_CUSTOM_GIT=y
+BR2_TARGET_ARM_TRUSTED_FIRMWARE_CUSTOM_REPO_URL="https://github.com/ARM-software/arm-trusted-firmware.git"
+BR2_TARGET_ARM_TRUSTED_FIRMWARE_PLATFORM="sun50i_h6"
+BR2_TARGET_ARM_TRUSTED_FIRMWARE_CUSTOM_REPO_VERSION="cffb00342897ed73a2bb9fc7a1860102bd927f2e"
+BR2_TARGET_ARM_TRUSTED_FIRMWARE_BL31=y

I've marked patches 2 to 4 in this series as Changes Requested.

Thomas
-- 
Thomas Petazzoni, CTO, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com