From mboxrd@z Thu Jan 1 00:00:00 1970 From: Arnout Vandecappelle Date: Wed, 13 Feb 2013 23:12:48 +0100 Subject: [Buildroot] [PATCH v3 1/1] openpgm: new package In-Reply-To: <1360749821-19238-1-git-send-email-alexander.lukichev@gmail.com> References: <1360749821-19238-1-git-send-email-alexander.lukichev@gmail.com> Message-ID: <511C0FE0.8020105@mind.be> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: buildroot@busybox.net On 13/02/13 11:03, Alexander Lukichev wrote: > OpenPGM is an open source implementation of the Pragmatic General > Multicast (PGM) specification in RFC 3208 available atwww.ietf.org. > It is required for PGM/EPGM support in ZeroMQ library. > > Signed-off-by: Alexander Lukichev > --- > v3: improved according to community suggestions: > - added Signed-off-by and the reason to the cross-compilation patch; > - specified toolchain requirements in Config.in. > > The package can be built without WCHAR but this is supported > only by its SCons and CMake build systems (for development). Autotools > based build system (for releases) does not support this. IPV6 and > thread support requirements are mandatory. In that case, why not just use cmake instead of autotools? Regards, Arnout -- Arnout Vandecappelle arnout at mind be Senior Embedded Software Architect +32-16-286500 Essensium/Mind http://www.mind.be G.Geenslaan 9, 3001 Leuven, Belgium BE 872 984 063 RPR Leuven LinkedIn profile: http://www.linkedin.com/in/arnoutvandecappelle GPG fingerprint: 7CB5 E4CC 6C2E EFD4 6E3D A754 F963 ECAB 2450 2F1F