From mboxrd@z Thu Jan 1 00:00:00 1970 From: Arnout Vandecappelle Date: Wed, 18 Mar 2015 23:42:12 +0100 Subject: [Buildroot] graphics In-Reply-To: References: Message-ID: <5509FF44.7080403@mind.be> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: buildroot@busybox.net On 16/03/15 11:01, ali hagigat wrote: > Buildroot has built a correct image for wandboard-quad and I can log > in and see the output by the serial port, ttymxc0 > But i want to enable graphics for wandboard. Now getty listens for > ttymxc0, how can i change it to use HDMI monitor and keyboard/mouse? > I have enabled some X11 components and some drivers but i can only see > the output on the serial console. HDMI monitor was not drived > I will be much appreciate for any answer getty will only give you a console. If you want to get a console on HDMI, you need CONFIG_VT and CONFIG_FB in the kernel, but I'm not sure if the latter is even available for the Wandboard. If you have a framebuffer, you can start a getty on tty1 instead of ttymxc0. But if it is X that you want, you should start it. For testing, you can just type X after logging in on the console. I think we should start writing a FAQ on how to use X on buildroot... Regards, Arnout -- Arnout Vandecappelle arnout at mind be Senior Embedded Software Architect +32-16-286500 Essensium/Mind http://www.mind.be G.Geenslaan 9, 3001 Leuven, Belgium BE 872 984 063 RPR Leuven LinkedIn profile: http://www.linkedin.com/in/arnoutvandecappelle GPG fingerprint: 7CB5 E4CC 6C2E EFD4 6E3D A754 F963 ECAB 2450 2F1F