From mboxrd@z Thu Jan 1 00:00:00 1970 From: Arnout Vandecappelle Date: Wed, 9 Sep 2015 23:38:32 +0200 Subject: [Buildroot] USB interface as a USB CDCEther (Communications Device Class Ethernet) In-Reply-To: References: Message-ID: <55F0A6D8.4040309@mind.be> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: buildroot@busybox.net On 09-09-15 20:49, Donahue, Bill wrote: > Hi, > > I am trying to set up the micro USB on my i.MX6 Rexboard to support Ethernet > messages over USB. > > I am using theLinux Kernel 4.1.4 and I have attached my config settings below. > > I have the board plugged into my Linux laptop but I can?t see the USB listed in > the /dev directory, how can I configure this? It's a network device, so no /dev node. You should have a network device called usb0. Do 'ifconfig -a' to check if it appears. Then you can assign a static IP address to both ends with ifconfig. Regards, Arnout PS This question is not really buildroot-related, obviously. -- Arnout Vandecappelle arnout at mind be Senior Embedded Software Architect +32-16-286500 Essensium/Mind http://www.mind.be G.Geenslaan 9, 3001 Leuven, Belgium BE 872 984 063 RPR Leuven LinkedIn profile: http://www.linkedin.com/in/arnoutvandecappelle GPG fingerprint: 7493 020B C7E3 8618 8DEC 222C 82EB F404 F9AC 0DDF