Re: [PATCH 6.1.y-cip 00/55] Add support for CRU/CSI2 on Renesas RZ/G3E

[Tommaso Merciai <tommaso.merciai.xr@bp.renesas.com>]

Hi Pavel,
Thanks for your review!

On Fri, Aug 22, 2025 at 01:37:27PM +0200, Pavel Machek wrote:
> Hi!
> 
> > Dear All,
> > 
> > This series adds support for the CRU/CSI2 IPs found in the Renesas RZ/G3E in
> > Linux 6.1.y-cip. These IPs are similar to those found on the RZ/V2H(P).
> > 
> > In addition, it includes patches required to successfully run the v4l2-compliance
> > tests against the OV5645 and the entire media pipeline.
> > 
> > This series has been tested on the following hardware setup:
> > 
> > OV5645 image sensor (Coral Camera) → RZ/G3E CSI2 → RZ/G3E CRU
> > 
> > The series applies on top of [1].
> > 
> > [1] https://patchwork.kernel.org/project/cip-dev/list/?series=993368&state=%2A&archive=both
> 
> I'm okay with Renesas patches, but perhaps we can skip ov5645 changes?


Patches for the OV5645 image sensor have been added to pass the v4l2-compliance test.
However, if this is not important, I’m okay with dropping those patches.

Using:
	v4l2-compliance --version
	v4l2-compliance 1.26.1-5142, 64 bits, 64-bit time_t
	v4l2-compliance SHA: 4aee01a02792 2023-12-12 21:40:38

We can always add them later if needed.

Thanks,
Tommaso

> 
> Best regards,
> 								Pavel
> -- 
> In cooperation with DENX Software Engineering GmbH, HRB 165235 Munich,
> Office: Kirchenstr.5, D-82194 Groebenzell, Germany