Re: path priority group and path state

[Christophe Varoqui <christophe.varoqui@free.fr>]

Please test 
http://christophe.varoqui.free.fr/multipath-tools/multipath-tools-0.4.3-pre3.tar.bz2
It should close the design hole you noted here.

regards,
cvaroqui

Caushik, Ramesh wrote:

>Given that some of the problems I am noticing in my testing relates to
>mismatch between the path state recorded by the driver and the daemon, I
>thought I will chime in with my questions / observations.
>   
>My setup consists of a dual port qla2312 controller connected to a JBOD
>through a FC switch thus creating 2 paths A & B to the drive. I have all
>the paths in one PG using round-robin selector and "queue if no path"
>set. I run a bonnie++ transfer to the mounted drive, and then pull out
>the path A connection. When the transfer switches to path B I reinsert A
>and then after a little while pull out B and repeat this a few times.
>Sometimes the transfer just hangs and the log messages indicate the
>driver is queueing the i/o (both paths are marked faulty). This is what
>seems to happen. When the cable on path  A is pulled out the controller
>receives a "LOOP DOWN" on that port and ALSO a "LIP RESET" on path B.
>This causes i/o on both paths to return SCSI error and so both paths are
>set faulty (some of the in-flight i/o on path B fails as a result of the
>LIP RESET). However when the daemon checker loop wakes up and tests the
>path (via checkfn) path B returns OK, and since the daemon will
>reconfigure the paths only if newstate != oldstate it does not
>reconfigure the path. As a result, we end up with a situation where the
>driver marks path B as faulty due to i/o error in the path, and waits
>for the daemon to reconfigure the path, while the daemon does not
>reconfigure path B because the checkfn does not detect a state change.
>First of all please tell me if this analyses is correct. If it is then
>my suggestion is for the daemon checker loop to reinstate the path
>anytime the there is a mismatch between the path state in the driver and
>that returned by the checkfn, and not just based on the newstate !=
>oldstate check. I am in the process of coding this up to see if it will
>fix the problem. Meanwhile I would much appreciate any comments or
>suggestions on this. Thanks,
>  
>