[PATCH] dmaengine: ti: k3-udma: enable compile testing

[Johan Hovold <johan@kernel.org>]

There does not seem to be anything preventing the K3 UDMA drivers from
being compile tested (on arm64 as one dependency depends on ARM64) so
enable compile testing for wider build coverage.

Note that the ring accelerator dependency can only be selected when
"TI SOC drivers support" (SOC_TI) is enabled so select that option too.

Signed-off-by: Johan Hovold <johan@kernel.org>
---
 drivers/dma/ti/Kconfig | 5 +++--
 1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/drivers/dma/ti/Kconfig b/drivers/dma/ti/Kconfig
index dbf168146d35..cbc30ab62783 100644
--- a/drivers/dma/ti/Kconfig
+++ b/drivers/dma/ti/Kconfig
@@ -36,11 +36,12 @@ config DMA_OMAP
 
 config TI_K3_UDMA
 	tristate "Texas Instruments UDMA support"
-	depends on ARCH_K3
+	depends on ARCH_K3 || COMPILE_TEST
 	depends on TI_SCI_PROTOCOL
 	depends on TI_SCI_INTA_IRQCHIP
 	select DMA_ENGINE
 	select DMA_VIRTUAL_CHANNELS
+	select SOC_TI
 	select TI_K3_RINGACC
 	select TI_K3_PSIL
         help
@@ -49,7 +50,7 @@ config TI_K3_UDMA
 
 config TI_K3_UDMA_GLUE_LAYER
 	tristate "Texas Instruments UDMA Glue layer for non DMAengine users"
-	depends on ARCH_K3
+	depends on ARCH_K3 || COMPILE_TEST
 	depends on TI_K3_UDMA
 	help
 	  Say y here to support the K3 NAVSS DMA glue interface
-- 
2.51.0