[PATCH] dmaengine: loongson: loongson2-apb: fix broken bus width validation in ls2x_dmac_detect_burst()

[David Carlier <devnexen@gmail.com>]

The bus width validation check in ls2x_dmac_detect_burst() compares raw
enum dma_slave_buswidth values (e.g. 4, 8) directly against
LDMA_SLAVE_BUSWIDTHS, which is a BIT()-encoded bitmask
(BIT(4) | BIT(8) = 0x110). Since 4 & 0x110 == 0 and 8 & 0x110 == 0,
the condition is always false for valid bus widths, making the
validation dead code.

Additionally, the logic was inverted: it rejected configurations where
both widths matched valid values, rather than rejecting when neither
width is supported.

Fix by wrapping the enum values with BIT() before masking (matching the
pattern used in sun6i-dma.c) and inverting the logic to reject when
neither width is supported by the hardware.

Fixes: 71e7d3cb6e55 ("dmaengine: ls2x-apb: New driver for the Loongson LS2X APB DMA controller")
Signed-off-by: David Carlier <devnexen@gmail.com>
---
 drivers/dma/loongson/loongson2-apb-dma.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/dma/loongson/loongson2-apb-dma.c b/drivers/dma/loongson/loongson2-apb-dma.c
index aceb069e71fc..102c01f993ef 100644
--- a/drivers/dma/loongson/loongson2-apb-dma.c
+++ b/drivers/dma/loongson/loongson2-apb-dma.c
@@ -220,8 +220,8 @@ static size_t ls2x_dmac_detect_burst(struct ls2x_dma_chan *lchan)
 	u32 maxburst, buswidth;
 
 	/* Reject definitely invalid configurations */
-	if ((lchan->sconfig.src_addr_width & LDMA_SLAVE_BUSWIDTHS) &&
-	    (lchan->sconfig.dst_addr_width & LDMA_SLAVE_BUSWIDTHS))
+	if (!(BIT(lchan->sconfig.src_addr_width) & LDMA_SLAVE_BUSWIDTHS) &&
+	    !(BIT(lchan->sconfig.dst_addr_width) & LDMA_SLAVE_BUSWIDTHS))
 		return 0;
 
 	if (lchan->sconfig.direction == DMA_MEM_TO_DEV) {
-- 
2.53.0