[PATCH 0/2] i2c: Add I2C High-Speed mode support for qcom-geni

[Jyothi Kumar Seerapu <jyothi.seerapu@oss.qualcomm.com>]

Add I2C High-Speed (HS) mode support for the Qualcomm GENI I2C
controller, detecting HS mode requests based on a 3.4 MHz bus
frequency.

I2C HS mode is supported by the underlying QUP hardware starting with
QUPv3 core version 4.3 (per the GENI/QUP Hardware Programming Guide).
This series adds the driver support to detect that capability and
enable HS-mode transfers on SoCs whose QUP core version meets that
requirement, rather than tying HS mode to any specific peripheral.

Patch 1 (dmaengine: qcom-gpi) is for GPI DMA transfers and adds
a CONFIG1 TRE to the GPI DMA engine to convey HS-specific timing
parameters (tcycle_cnt/tlow_cnt) to the hardware.

Patch 2 (i2c: qcom-geni) handles FIFO/SE-DMA transfers; It configures
the GENI controller's source clock and timing accordingly, and adds
the HS-specific FIFO/SE-DMA opcodes and master-code preamble needed
to switch the bus from Fast Mode Plus to HS speed.

Signed-off-by: Jyothi Kumar Seerapu <jyothi.seerapu@oss.qualcomm.com>
---
Jyothi Kumar Seerapu (2):
      dmaengine: qcom-gpi: Add I2C High-Speed mode configuration support
      i2c: qcom-geni: Add support for I2C High-Speed mode

 drivers/dma/qcom/gpi.c             |  54 +++++++++++++--
 drivers/i2c/busses/i2c-qcom-geni.c | 133 +++++++++++++++++++++++++++++++++----
 include/linux/dma/qcom-gpi-dma.h   |  28 +++++++-
 3 files changed, 196 insertions(+), 19 deletions(-)
---
base-commit: 7079a12d7506b07fb53b54a664bfad5fa9b16d70
change-id: 20260821-i2c-hs-408768509865

Best regards,
--  
Jyothi Kumar Seerapu <jyothi.seerapu@oss.qualcomm.com>