From mboxrd@z Thu Jan 1 00:00:00 1970 From: Wang Xiao W Subject: [PATCH 15/16] fm10k: fix iov_msg_lport_state_pf re-enable bug Date: Mon, 27 Jul 2015 16:42:38 +0800 Message-ID: <1437986559-31016-15-git-send-email-xiao.w.wang@intel.com> References: <1437986559-31016-1-git-send-email-xiao.w.wang@intel.com> Cc: Wang Xiao W To: dev@dpdk.org Return-path: Received: from mga14.intel.com (mga14.intel.com [192.55.52.115]) by dpdk.org (Postfix) with ESMTP id A14A4C576 for ; Mon, 27 Jul 2015 10:43:22 +0200 (CEST) In-Reply-To: <1437986559-31016-1-git-send-email-xiao.w.wang@intel.com> List-Id: patches and discussions about DPDK List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Errors-To: dev-bounces@dpdk.org Sender: "dev" When a VF issues an LPORT_STATE request to enable a port which is already enabled, the PF will first disable the VF. Then it is supposed to re-enable the VF again with new settings. This is primarily done in order to ensure that the switch management software properly clears the previous VF settings. (ie: switch flow rules and so forth). However, there is a bug in the flow because we check if VF is enabled and don't re-enable it at the end. The issue is that we disable the VF in order to clear switch rules, and never follow-up with a re-enable. This results in a call to enable the VF results in disabling the logical port. Signed-off-by: Wang Xiao W --- drivers/net/fm10k/base/fm10k_pf.c | 8 ++++++++ 1 file changed, 8 insertions(+) diff --git a/drivers/net/fm10k/base/fm10k_pf.c b/drivers/net/fm10k/base/fm10k_pf.c index 86283fa..aa04937 100644 --- a/drivers/net/fm10k/base/fm10k_pf.c +++ b/drivers/net/fm10k/base/fm10k_pf.c @@ -1418,6 +1418,14 @@ s32 fm10k_iov_msg_lport_state_pf(struct fm10k_hw *hw, u32 **results, err = fm10k_update_lport_state_pf(hw, vf_info->glort, 1, false); + /* need to clear VF_FLAG_ENABLED in order to ensure that we + * actually re-enable the lport state below. Note that this + * has no impact if VF is already disabled, as the flags are + * already zeroed. + */ + if (!err) + vf_info->vf_flags = FM10K_VF_FLAG_CAPABLE(vf_info); + /* when enabling the port we should reset the rate limiters */ hw->iov.ops.configure_tc(hw, vf_info->vf_idx, vf_info->rate); -- 1.9.3