[PATCH 15/45] net/dpaa2: set Tx confirmation on device init

[Prashant Gupta <prashant.gupta_3@nxp.com>]

From: Gagandeep Singh <g.singh@nxp.com>

Move TX confirmation mode setting from TXQ setup to device
initialization because TXQ0 is not always set up by the user.

Signed-off-by: Jun Yang <jun.yang@nxp.com>
Signed-off-by: Gagandeep Singh <g.singh@nxp.com>
---
 drivers/net/dpaa2/dpaa2_ethdev.c | 40 ++++++++++++--------------------
 1 file changed, 15 insertions(+), 25 deletions(-)

diff --git a/drivers/net/dpaa2/dpaa2_ethdev.c b/drivers/net/dpaa2/dpaa2_ethdev.c
index f211357919..c95704d4ca 100644
--- a/drivers/net/dpaa2/dpaa2_ethdev.c
+++ b/drivers/net/dpaa2/dpaa2_ethdev.c
@@ -1153,7 +1153,6 @@ dpaa2_dev_tx_queue_setup(struct rte_eth_dev *dev,
 	struct dpni_queue tx_conf_cfg;
 	struct dpni_queue tx_flow_cfg;
 	uint8_t options = 0, flow_id;
-	uint8_t ceetm_ch_idx;
 	uint16_t channel_id;
 	struct dpni_queue_id qid;
 	uint32_t tc_id;
@@ -1174,30 +1173,6 @@ dpaa2_dev_tx_queue_setup(struct rte_eth_dev *dev,
 	memset(&tx_conf_cfg, 0, sizeof(struct dpni_queue));
 	memset(&tx_flow_cfg, 0, sizeof(struct dpni_queue));
 
-	if (!tx_queue_id) {
-		for (ceetm_ch_idx = 0;
-			ceetm_ch_idx <= (priv->num_channels - 1);
-			ceetm_ch_idx++) {
-			/*Set tx-conf and error configuration*/
-			if (priv->flags & DPAA2_TX_CONF_ENABLE) {
-				ret = dpni_set_tx_confirmation_mode(dpni,
-						CMD_PRI_LOW, priv->token,
-						ceetm_ch_idx,
-						DPNI_CONF_AFFINE);
-			} else {
-				ret = dpni_set_tx_confirmation_mode(dpni,
-						CMD_PRI_LOW, priv->token,
-						ceetm_ch_idx,
-						DPNI_CONF_DISABLE);
-			}
-			if (ret) {
-				DPAA2_PMD_ERR("Error(%d) in tx conf setting",
-					ret);
-				return ret;
-			}
-		}
-	}
-
 	tc_id = tx_queue_id % priv->num_tx_tc;
 	channel_id = (uint8_t)(tx_queue_id / priv->num_tx_tc) % priv->num_channels;
 	flow_id = 0;
@@ -3624,6 +3599,21 @@ dpaa2_dev_init(struct rte_eth_dev *eth_dev)
 		goto init_err;
 	}
 
+	for (i = 0; i < priv->num_channels; i++) {
+		/*Set tx-conf and error configuration*/
+		if (priv->flags & DPAA2_TX_CONF_ENABLE) {
+			ret = dpni_set_tx_confirmation_mode(dpni_dev,
+				CMD_PRI_LOW, priv->token, i, DPNI_CONF_AFFINE);
+		} else {
+			ret = dpni_set_tx_confirmation_mode(dpni_dev,
+				CMD_PRI_LOW, priv->token, i, DPNI_CONF_DISABLE);
+		}
+		if (ret) {
+			DPAA2_PMD_ERR("Error(%d) in tx conf setting", ret);
+			goto init_err;
+		}
+	}
+
 	/* Allocate memory for storing MAC addresses.
 	 * Table of mac_filter_entries size is allocated so that RTE ether lib
 	 * can add MAC entries when rte_eth_dev_mac_addr_add is called.
-- 
2.43.0