#
# drbd.conf example
#

resource RHEL0 {

  # transfer protocol to use.
  # C: write IO is reported as completed, if we know it has
  #    reached _both_ local and remote DISK.
  #    * for critical transactional data.
  # B: write IO is reported as completed, if it has reached
  #    local DISK and remote buffer cache.
  #    * for most cases.
  # A: write IO is reported as completed, if it has reached
  #    local DISK and local tcp send buffer. (see also sndbuf-size)
  #    * for high latency networks
  #
  #**********
  # uhm, benchmarks have shown that C is actually better than B.
  # this note shall disappear, when we are convinced that B is
  # the right choice "for most cases".
  # Until then, always use C unless you have a reason not to.
  #	--lge
  #**********
  #
  protocol C;

  # what should be done in case the cluster starts up in
  # degraded mode, but knows it has inconsistent data.
#  incon-degr-cmd "echo '!DRBD! pri on incon-degr' | wall ; sleep 60 ; halt -f";

  startup {
    # Wait for connection timeout. 
    # The init script blocks the boot process until the resources
    # are connected. This is so when the cluster manager starts later,
    # it does not see a resource with internal split-brain.
    # In case you want to limit the wait time, do it here.
    # Default is 0, which means unlimited. Unit is seconds.
    #
     wfc-timeout  30;

    # Wait for connection timeout if this node was a degraded cluster.
    # In case a degraded cluster (= cluster with only one node left)
    # is rebooted, this timeout value is used. 
    #
    degr-wfc-timeout 120;    # 2 minutes.
  }

  syncer {
    # Limit the bandwith used by the resynchronisation process.
    # default unit is KB/sec; optional suffixes K,M,G are allowed
    #
    rate 100M;

  }

  on trumpkin {
    device     /dev/drbd0;
    disk       /dev/sdb2;
    address    172.17.100.211:60003;
    meta-disk  /dev/sdb7[0];

    # meta-disk is either 'internal' or '/dev/ice/name [idx]'
    #
    # You can use a single block device to store meta-data
    # of multiple DRBD's.
    # E.g. use meta-disk /dev/hde6[0]; and meta-disk /dev/hde6[1];
    # for two different resources. In this case the meta-disk
    # would need to be at least 256 MB in size.
    #
    # 'internal' means, that the last 128 MB of the lower device
    # are used to store the meta-data.
    # You must not give an index with 'internal'.
  }

  on tumnus {
    device    /dev/drbd0;
    disk      /dev/sdb2;
    address   172.17.100.210:60003;
    meta-disk /dev/sdb7[0];
  }
}