[PATCH AUTOSEL 5.12 043/134] backlight: qcom-wled: Use sink_addr for sync toggle

[Sasha Levin <sashal@kernel.org>]

From: Obeida Shamoun <oshmoun100@googlemail.com>

[ Upstream commit cdfd4c689e2a52c313b35ddfc1852ff274f91acb ]

WLED3_SINK_REG_SYNC is, as the name implies, a sink register offset.
Therefore, use the sink address as base instead of the ctrl address.

This fixes the sync toggle on wled4, which can be observed by the fact
that adjusting brightness now works.

It has no effect on wled3 because sink and ctrl base addresses are the
same.  This allows adjusting the brightness without having to disable
then reenable the module.

Signed-off-by: Obeida Shamoun <oshmoun100@googlemail.com>
Signed-off-by: Konrad Dybcio <konrad.dybcio@somainline.org>
Signed-off-by: Marijn Suijten <marijn.suijten@somainline.org>
Reviewed-by: Daniel Thompson <daniel.thompson@linaro.org>
Acked-by: Kiran Gunda <kgunda@codeaurora.org>
Signed-off-by: Lee Jones <lee.jones@linaro.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 drivers/video/backlight/qcom-wled.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/video/backlight/qcom-wled.c b/drivers/video/backlight/qcom-wled.c
index 091f07e7c145..fc8b443d10fd 100644
--- a/drivers/video/backlight/qcom-wled.c
+++ b/drivers/video/backlight/qcom-wled.c
@@ -336,13 +336,13 @@ static int wled3_sync_toggle(struct wled *wled)
 	unsigned int mask = GENMASK(wled->max_string_count - 1, 0);
 
 	rc = regmap_update_bits(wled->regmap,
-				wled->ctrl_addr + WLED3_SINK_REG_SYNC,
+				wled->sink_addr + WLED3_SINK_REG_SYNC,
 				mask, mask);
 	if (rc < 0)
 		return rc;
 
 	rc = regmap_update_bits(wled->regmap,
-				wled->ctrl_addr + WLED3_SINK_REG_SYNC,
+				wled->sink_addr + WLED3_SINK_REG_SYNC,
 				mask, WLED3_SINK_REG_SYNC_CLEAR);
 
 	return rc;
-- 
2.30.2

_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel