dri-devel Archive on lore.kernel.org
 help / color / mirror / Atom feed
From: sashiko-bot@kernel.org
To: "Dmitry Baryshkov" <dmitry.baryshkov@oss.qualcomm.com>
Cc: dri-devel@lists.freedesktop.org
Subject: Re: [PATCH 05/24] drm/msm: route the display snapshot through the msm_display interface
Date: Wed, 22 Jul 2026 06:56:25 +0000	[thread overview]
Message-ID: <20260722065626.10C141F000E9@smtp.kernel.org> (raw)
In-Reply-To: <20260722-drm-msm-display-interface-v1-5-368c10fe62fd@oss.qualcomm.com>

Thank you for your contribution! Sashiko AI review found 1 potential issue(s) to consider:

Pre-existing issues:
- [High] TOCTOU race condition checking `dp->power_on` locklessly, which can lead to an unclocked MMIO read and system crash.
--

--- Patch [5]: [PATCH 05/24] drm/msm: route the display snapshot through the msm_display interface ---
commit ccee48fbd111a360e4e514435d662edafb46b06b
Author: Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com>

drm/msm: route the display snapshot through the msm_display interface

This commit refactors the display snapshot code to use a mandatory snapshot()
callback in struct msm_display_funcs. DSI and DP snapshot helpers are
turned into implementations of this callback, and an empty one is provided
for HDMI.

[ ... ]

> diff --git a/drivers/gpu/drm/msm/dp/dp_display.c b/drivers/gpu/drm/msm/dp/dp_display.c
> index 79dd556e96c27..f4fa86d1b9c77 100644
> --- a/drivers/gpu/drm/msm/dp/dp_display.c
> +++ b/drivers/gpu/drm/msm/dp/dp_display.c
> @@ -783,8 +783,10 @@ int msm_dp_display_get_test_bpp(struct msm_dp *dp)
>  		msm_dp_display->link->test_video.test_bit_depth);
>  }
>  
> -void msm_dp_snapshot(struct msm_disp_state *disp_state, struct msm_dp *dp)
> +static void msm_dp_snapshot(struct msm_display *display,
> +			    struct msm_disp_state *disp_state)
>  {
> +	struct msm_dp *dp = container_of(display, struct msm_dp, display);
>  	struct msm_dp_display_private *msm_dp_display;

[Severity: High]
This is a pre-existing issue, but could the lockless check of dp->power_on
further down in msm_dp_snapshot() lead to an unclocked MMIO read?

If a concurrent modeset disable or hotplug unplug event disables the DP
controller's clocks and sets dp->power_on to false right after the lockless
if (!dp->power_on) check, the snapshot thread might proceed to read the
hardware registers in msm_disp_snapshot_add_block() without the clocks.

Reading MMIO registers while the DP clocks are disabled causes an AHB bus
hang, leading to a fatal system crash (SError) on Snapdragon hardware.

Should pm_runtime_get_sync() be used around the hardware access here,
similar to how it is handled in msm_dsi_host_snapshot()?

-- 
Sashiko AI review · https://sashiko.dev/#/patchset/20260722-drm-msm-display-interface-v1-0-368c10fe62fd@oss.qualcomm.com?part=5

  reply	other threads:[~2026-07-22  6:56 UTC|newest]

Thread overview: 36+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2026-07-22  6:36 [PATCH 00/24] drm/msm: introduce the struct msm_display interface Dmitry Baryshkov
2026-07-22  6:36 ` [PATCH 01/24] drm/msm/dp: reject YUV420-only modes without VSC SDP support Dmitry Baryshkov
2026-07-22  7:03   ` sashiko-bot
2026-07-22  6:36 ` [PATCH 02/24] drm/msm/dp: drop the always-true yuv_supported argument Dmitry Baryshkov
2026-07-22  6:36 ` [PATCH 03/24] drm/msm: create the display connectors from common code Dmitry Baryshkov
2026-07-22  7:04   ` sashiko-bot
2026-07-22  6:36 ` [PATCH 04/24] drm/msm: introduce the struct msm_display interface Dmitry Baryshkov
2026-07-22  6:36 ` [PATCH 05/24] drm/msm: route the display snapshot through the " Dmitry Baryshkov
2026-07-22  6:56   ` sashiko-bot [this message]
2026-07-22  6:36 ` [PATCH 06/24] drm/msm/hdmi: capture the HDMI registers in the display snapshot Dmitry Baryshkov
2026-07-22  6:59   ` sashiko-bot
2026-07-22  6:36 ` [PATCH 07/24] drm/msm: add the wide_bus_enabled callback to msm_display Dmitry Baryshkov
2026-07-22  6:36 ` [PATCH 08/24] drm/msm: add the needs_periph_flush " Dmitry Baryshkov
2026-07-22  6:36 ` [PATCH 09/24] drm/msm: add the is_cmd_mode " Dmitry Baryshkov
2026-07-22  6:36 ` [PATCH 10/24] drm/msm: add the get_dsc_config " Dmitry Baryshkov
2026-07-22  6:36 ` [PATCH 11/24] drm/msm: add the get_te_source " Dmitry Baryshkov
2026-07-22  6:36 ` [PATCH 12/24] drm/msm: add is_bonded and needs_encoder callbacks " Dmitry Baryshkov
2026-07-22  6:36 ` [PATCH 13/24] drm/msm/hdmi: use dev_get_drvdata() in msm_hdmi_unbind() Dmitry Baryshkov
2026-07-22  7:03   ` sashiko-bot
2026-07-22  6:36 ` [PATCH 14/24] drm/msm: store the display sub-blocks as struct msm_display Dmitry Baryshkov
2026-07-22  6:36 ` [PATCH 15/24] drm/msm/dp: do not reject wide-bus modes while a YUV420 mode is active Dmitry Baryshkov
2026-07-22  7:03   ` sashiko-bot
2026-07-22  6:36 ` [PATCH 16/24] drm/msm/dp: remove cached drm_edid from panel Dmitry Baryshkov
2026-07-22  7:08   ` sashiko-bot
2026-07-22  6:36 ` [PATCH 17/24] drm/msm/dp: drop deprecated .mode_set() and use .atomic_pre_enable Dmitry Baryshkov
2026-07-22  6:36 ` [PATCH 18/24] drm/msm/hdmi: cache is_hdmi instead of storing the connector Dmitry Baryshkov
2026-07-22  7:06   ` sashiko-bot
2026-07-22  6:36 ` [PATCH 19/24] drm/msm/dp: drop redundant panel->connector Dmitry Baryshkov
2026-07-22  6:36 ` [PATCH 20/24] drm/msm/dp: use drm_display_info in mode_valid callbacks Dmitry Baryshkov
2026-07-22  6:36 ` [PATCH 21/24] drm/msm/dp: guard subconnector setup on the connector type Dmitry Baryshkov
2026-07-22  6:36 ` [PATCH 22/24] drm/msm/dp: stop storing the connector in struct msm_dp Dmitry Baryshkov
2026-07-22  7:12   ` sashiko-bot
2026-07-22  6:36 ` [PATCH 23/24] drm/msm: create the bridge connectors from common code Dmitry Baryshkov
2026-07-22  7:04   ` sashiko-bot
2026-07-22  6:36 ` [PATCH 24/24] drm/bridge-connector: attach the DP subconnector property Dmitry Baryshkov
2026-07-22  7:05   ` sashiko-bot

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20260722065626.10C141F000E9@smtp.kernel.org \
    --to=sashiko-bot@kernel.org \
    --cc=dmitry.baryshkov@oss.qualcomm.com \
    --cc=dri-devel@lists.freedesktop.org \
    --cc=sashiko-reviews@lists.linux.dev \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox