From: Chris Zhong <zyw@rock-chips.com>
To: John Keeping <john@metanate.com>, Mark Yao <mark.yao@rock-chips.com>
Cc: linux-arm-kernel@lists.infradead.org,
linux-rockchip@lists.infradead.org, linux-kernel@vger.kernel.org,
dri-devel@lists.freedesktop.org
Subject: Re: [05/26] drm/rockchip: dw-mipi-dsi: fix command header writes
Date: Tue, 17 Jan 2017 17:32:30 +0800 [thread overview]
Message-ID: <587DE4AE.8070608@rock-chips.com> (raw)
In-Reply-To: <20160919171747.28512-6-john@metanate.com>
same as https://patchwork.kernel.org/patch/9518417/
Tested-by: Chris Zhong <zyw@rock-chips.com>
Reviewed-by: Chris Zhong <zyw@rock-chips.com>
On 09/20/2016 01:17 AM, John Keeping wrote:
> In a couple of places here we use "val" for the value that is about to
> be written to a register but then reuse the same variable for the value
> of a status register before we get around to writing it. Rename the
> value to be written to so that we write the value we intend to and not
> what we have just read from the status register.
>
> Signed-off-by: John Keeping <john@metanate.com>
> ---
> drivers/gpu/drm/rockchip/dw-mipi-dsi.c | 10 ++++++----
> 1 file changed, 6 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
> index fac2429b9d6d..03915bf9c97d 100644
> --- a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
> +++ b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
> @@ -543,9 +543,10 @@ static int dw_mipi_dsi_host_detach(struct mipi_dsi_host *host,
> return 0;
> }
>
> -static int dw_mipi_dsi_gen_pkt_hdr_write(struct dw_mipi_dsi *dsi, u32 val)
> +static int dw_mipi_dsi_gen_pkt_hdr_write(struct dw_mipi_dsi *dsi, u32 hdr_val)
> {
> int ret;
> + u32 val;
>
> ret = readx_poll_timeout(readl, dsi->base + DSI_CMD_PKT_STATUS,
> val, !(val & GEN_CMD_FULL), 1000,
> @@ -555,7 +556,7 @@ static int dw_mipi_dsi_gen_pkt_hdr_write(struct dw_mipi_dsi *dsi, u32 val)
> return ret;
> }
>
> - dsi_write(dsi, DSI_GEN_HDR, val);
> + dsi_write(dsi, DSI_GEN_HDR, hdr_val);
>
> ret = readx_poll_timeout(readl, dsi->base + DSI_CMD_PKT_STATUS,
> val, val & (GEN_CMD_EMPTY | GEN_PLD_W_EMPTY),
> @@ -588,8 +589,9 @@ static int dw_mipi_dsi_dcs_long_write(struct dw_mipi_dsi *dsi,
> {
> const u32 *tx_buf = msg->tx_buf;
> int len = msg->tx_len, pld_data_bytes = sizeof(*tx_buf), ret;
> - u32 val = GEN_HDATA(msg->tx_len) | GEN_HTYPE(msg->type);
> + u32 hdr_val = GEN_HDATA(msg->tx_len) | GEN_HTYPE(msg->type);
> u32 remainder = 0;
> + u32 val;
>
> if (msg->tx_len < 3) {
> dev_err(dsi->dev, "wrong tx buf length %zu for long write\n",
> @@ -618,7 +620,7 @@ static int dw_mipi_dsi_dcs_long_write(struct dw_mipi_dsi *dsi,
> }
> }
>
> - return dw_mipi_dsi_gen_pkt_hdr_write(dsi, val);
> + return dw_mipi_dsi_gen_pkt_hdr_write(dsi, hdr_val);
> }
>
> static ssize_t dw_mipi_dsi_host_transfer(struct mipi_dsi_host *host,
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel
next prev parent reply other threads:[~2017-01-17 9:32 UTC|newest]
Thread overview: 42+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-09-19 17:17 [PATCH 00/27] drm/rockchip: MIPI fixes & improvements John Keeping
2016-09-19 17:17 ` [PATCH 01/26] drm/rockchip: dw-mipi-dsi: use mode from display state John Keeping
2017-01-17 10:38 ` [01/26] " Chris Zhong
2017-01-18 2:21 ` Mark yao
2016-09-19 17:17 ` [PATCH 03/26] drm/rockchip: dw-mipi-dsi: don't configure hardware in mode_set for MIPI John Keeping
2016-09-19 17:17 ` [PATCH 04/26] drm/rockchip: dw-mipi-dsi: rename commit hook to enable John Keeping
2016-09-19 17:17 ` [PATCH 05/26] drm/rockchip: dw-mipi-dsi: fix command header writes John Keeping
2017-01-17 9:32 ` Chris Zhong [this message]
2016-09-19 17:17 ` [PATCH 07/26] drm/rockchip: dw-mipi-dsi: avoid out-of-bounds read on tx_buf John Keeping
2016-09-19 17:17 ` [PATCH 08/26] drm/rockchip: dw-mipi-dsi: include bad value in error message John Keeping
2016-09-19 17:17 ` [PATCH 09/26] drm/rockchip: dw-mipi-dsi: respect message flags John Keeping
2016-09-19 17:17 ` [PATCH 10/26] drm/rockchip: dw-mipi-dsi: only request HS clock when required John Keeping
2016-09-19 17:17 ` [PATCH 11/26] drm/rockchip: dw-mipi-dsi: don't assume buffer is aligned John Keeping
2016-09-19 17:17 ` [PATCH 12/26] drm/rockchip: dw-mipi-dsi: prepare panel after phy init John Keeping
2016-09-19 17:17 ` [PATCH 14/26] drm/rockchip: dw-mipi-dsi: fix escape clock rate John Keeping
2016-09-19 17:17 ` [PATCH 14/27] drm/rockchip: dw-mipi-dsi: use specific poll helper John Keeping
2016-09-19 17:17 ` [PATCH 15/26] drm/rockchip: dw-mipi-dsi: ensure PHY is reset John Keeping
2016-09-19 17:17 ` [PATCH 16/26] drm/rockchip: dw-mipi-dsi: configure bias and bandgap before enable John Keeping
2016-09-19 17:17 ` [PATCH 17/27] drm/rockchip: dw-mipi-dsi: ensure PHY is reset John Keeping
2016-09-19 17:17 ` [PATCH 18/27] drm/rockchip: dw-mipi-dsi: configure bias and bandgap before enable John Keeping
2016-09-19 17:17 ` [PATCH 19/27] drm/rockchip: dw-mipi-dsi: don't enable PHY PLL until it's configured John Keeping
2016-09-19 17:17 ` [PATCH 19/26] drm/rockchip: dw-mipi-dsi: improve PLL configuration John Keeping
2016-09-19 17:17 ` [PATCH 20/27] drm/rockchip: dw-mipi-dsi: properly configure PHY timing John Keeping
[not found] ` <20160919171747.28512-1-john-HooS5bfzL4hWk0Htik3J/w@public.gmane.org>
2016-09-19 17:17 ` [PATCH 02/26] drm/rockchip: dw-mipi-dsi: pass new mode into MIPI mode set John Keeping
2016-09-19 17:17 ` [PATCH 06/26] drm/rockchip: dw-mipi-dsi: fix generic packet status check John Keeping
2016-09-19 17:17 ` [PATCH 13/26] drm/rockchip: dw-mipi-dsi: allow commands in panel_disable John Keeping
2016-09-19 17:17 ` [PATCH 15/27] drm/rockchip: dw-mipi-dsi: use positive check for N{H, V}SYNC John Keeping
2016-09-19 17:17 ` [PATCH 16/27] drm/rockchip: dw-mipi-dsi: fix escape clock rate John Keeping
2016-09-19 17:17 ` [PATCH 17/26] drm/rockchip: dw-mipi-dsi: don't enable PHY PLL until it's configured John Keeping
2016-09-19 17:17 ` [PATCH 18/26] drm/rockchip: dw-mipi-dsi: properly configure PHY timing John Keeping
2016-09-19 17:17 ` [PATCH 20/26] drm/rockchip: dw-mipi-dsi: use specific poll helper John Keeping
2016-09-19 17:17 ` [PATCH 21/27] drm/rockchip: dw-mipi-dsi: improve PLL configuration John Keeping
2016-09-19 17:17 ` [PATCH 21/26] drm/rockchip: dw-mipi-dsi: use positive check for N{H, V}SYNC John Keeping
2016-09-19 17:17 ` [PATCH 22/27] drm/rockchip: dw-mipi-dsi: defer probe if panel is not loaded John Keeping
2016-09-19 17:17 ` [PATCH 22/26] drm/rockchip: vop: test for P{H,V}SYNC John Keeping
2016-09-19 17:17 ` [PATCH 23/26] drm/rockchip: dw-mipi-dsi: defer probe if panel is not loaded John Keeping
2016-09-19 17:17 ` [PATCH 23/27] drm/rockchip: dw-mipi-dsi: support non-burst modes John Keeping
2016-09-19 17:17 ` [PATCH 24/26] " John Keeping
2016-09-19 17:17 ` [PATCH 24/27] drm/rockchip: vop: test for P{H,V}SYNC John Keeping
2016-09-19 17:17 ` [PATCH 25/26] drm/rockchip: dw-mipi-dsi: add reset control John Keeping
2016-09-19 17:17 ` [PATCH 26/26] drm/rockchip: dw-mipi-dsi: support read commands John Keeping
2016-09-19 17:24 ` [PATCH 00/27] drm/rockchip: MIPI fixes & improvements John Keeping
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=587DE4AE.8070608@rock-chips.com \
--to=zyw@rock-chips.com \
--cc=dri-devel@lists.freedesktop.org \
--cc=john@metanate.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-rockchip@lists.infradead.org \
--cc=mark.yao@rock-chips.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).