On 9/3/2024 4:48 PM, Andrzej Hajda wrote:
>
>
> On 29.08.2024 20:00, Nirmoy Das wrote:
>> Tests that are causing pagefaults should wait for exec to queue
>> ban/finish otherwise pending engine resets because of on-going
>> pagefaults would cause failure in subsequent tests to fail.
>>
>> Not all execs will generate page faults and in such case reading ban
>> property is not enough but the signal should either -EIO or 0.
>> so read that instead.
>>
>> v2: specify timeout reason and iterate over exec_queues(Andrzej)
>> v3: increase timeout
>> v4: check for signal status to be -EIO/0.
>>
>> Cc: Andrzej Hajda<andrzej.hajda@intel.com>
>> Cc: Kamil Konieczny<kamil.konieczny@linux.intel.com>
>> Cc: Matthew Brost<matthew.brost@intel.com>
>> Cc: Tejas Upadhyay<tejas.upadhyay@intel.com>
>> Link:https://gitlab.freedesktop.org/drm/xe/kernel/-/issues/1630
>> Signed-off-by: Nirmoy Das<nirmoy.das@intel.com>
>> ---
>>   tests/intel/xe_exec_fault_mode.c | 11 +++++++++++
>>   1 file changed, 11 insertions(+)
>>
>> diff --git a/tests/intel/xe_exec_fault_mode.c b/tests/intel/xe_exec_fault_mode.c
>> index 1f1f1e50b..fa050d0dc 100644
>> --- a/tests/intel/xe_exec_fault_mode.c
>> +++ b/tests/intel/xe_exec_fault_mode.c
>> @@ -329,6 +329,17 @@ test_exec(int fd, struct drm_xe_engine_class_instance *eci,
>>   				igt_assert_eq(data[i].data, 0xc0ffee);
>>   	}
>>   
>> +	if ((flags & INVALID_FAULT)) {
>> +		for (i = 0; i < n_execs; i++) {
>> +			int ret;
>> +			int64_t timeout = NSEC_PER_SEC;
>> +
>> +			ret = __xe_wait_ufence(fd, &data[i].exec_sync, USER_FENCE_VALUE,
>> +					       exec_queues[i % n_exec_queues], &timeout);
>> +			igt_assert(ret == -EIO || ret ==0);
>
> "ret ==0" - missing space.

I will fix it.


> Btw in theory we have n_execs * 1second  (128sec???) total wait time.


We will be trouble if this ever happens for one store instruction :) I 
could add a 1sec wait and then run the

loop but I think that is not needed.

>> +		}
>> +	}
>> +
>
> If I placed change correctly in the code it could be replaced by chain:
> if ((flags & INVALID_FAULT)) {
>     // your change
> } else if !(flags & INVALID_VA) { ... } 


That fits well, I will do that.

> Up to you. Reviewed-by: Andrzej Hajda <andrzej.hajda@intel.com>


Thanks,

Nirmoy

> Regards Andrzej
>>   	for (i = 0; i < n_exec_queues; i++) {
>>   		xe_exec_queue_destroy(fd, exec_queues[i]);
>>   		if (bind_exec_queues[i])
>