[PATCH net] net: fec: fix the unhandled context fault from smmu

[Shenwei Wang <shenwei.wang@nxp.com>]

When repeatedly changing the interface link speed using the command below:

ethtool -s eth0 speed 100 duplex full
ethtool -s eth0 speed 1000 duplex full

The following errors may sometimes be reported by the ARM SMMU driver:

[ 5395.035364] fec 5b040000.ethernet eth0: Link is Down
[ 5395.039255] arm-smmu 51400000.iommu: Unhandled context fault:
fsr=0x402, iova=0x00000000, fsynr=0x100001, cbfrsynra=0x852, cb=2
[ 5398.108460] fec 5b040000.ethernet eth0: Link is Up - 100Mbps/Full -
flow control off

It is identified that the FEC driver does not properly stop the TX queue
during the link speed transitions, and this results in the invalid virtual
I/O address translations from the SMMU and causes the context faults.

Fixes: dbc64a8ea231 ("net: fec: move calls to quiesce/resume packet processing out of fec_restart()")
Signed-off-by: Shenwei Wang <shenwei.wang@nxp.com>
---
 drivers/net/ethernet/freescale/fec_main.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/net/ethernet/freescale/fec_main.c b/drivers/net/ethernet/freescale/fec_main.c
index d42594f32275..f2bab7239776 100644
--- a/drivers/net/ethernet/freescale/fec_main.c
+++ b/drivers/net/ethernet/freescale/fec_main.c
@@ -2036,6 +2036,7 @@ static void fec_enet_adjust_link(struct net_device *ndev)
 
 		/* if any of the above changed restart the FEC */
 		if (status_change) {
+			netif_stop_queue(ndev);
 			napi_disable(&fep->napi);
 			netif_tx_lock_bh(ndev);
 			fec_restart(ndev);
@@ -2045,6 +2046,7 @@ static void fec_enet_adjust_link(struct net_device *ndev)
 		}
 	} else {
 		if (fep->link) {
+			netif_stop_queue(ndev);
 			napi_disable(&fep->napi);
 			netif_tx_lock_bh(ndev);
 			fec_stop(ndev);
-- 
2.34.1