[PATCH] drm/i915: avoid unclaimed registers when capturing the error state

[Paulo Zanoni <przanoni@gmail.com>]

From: Paulo Zanoni <paulo.r.zanoni@intel.com>

Even though we only check for unclaimed registers while we're writing
registers, if we read a bad register we'll still trigger a CPU error
interrupt, and we'll print an "Unclaimed register" DRM_ERROR due to
that. To avoid this error, just avoid touching power domains that are
not enabled.

Use kzalloc so we're sure all the disabled domains will be zeroed on
the error state file. We already print the information that is enough
to discover if the power well is enabled on the error state file, so
this should not be a problem.

Bugzilla: https://bugs.freedesktop.org/show_bug.cgi?id=69747
Signed-off-by: Paulo Zanoni <paulo.r.zanoni@intel.com>
---
 drivers/gpu/drm/i915/intel_display.c | 15 ++++++++-------
 1 file changed, 8 insertions(+), 7 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index e841cd7..fba7d9b 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -11138,7 +11138,7 @@ intel_display_capture_error_state(struct drm_device *dev)
 	if (INTEL_INFO(dev)->num_pipes == 0)
 		return NULL;
 
-	error = kmalloc(sizeof(*error), GFP_ATOMIC);
+	error = kzalloc(sizeof(*error), GFP_ATOMIC);
 	if (error == NULL)
 		return NULL;
 
@@ -11146,6 +11146,9 @@ intel_display_capture_error_state(struct drm_device *dev)
 		error->power_well_driver = I915_READ(HSW_PWR_WELL_DRIVER);
 
 	for_each_pipe(i) {
+		if (!intel_display_power_enabled(dev, POWER_DOMAIN_PIPE(i)))
+			continue;
+
 		if (INTEL_INFO(dev)->gen <= 6 || IS_VALLEYVIEW(dev)) {
 			error->cursor[i].control = I915_READ(CURCNTR(i));
 			error->cursor[i].position = I915_READ(CURPOS(i));
@@ -11179,6 +11182,10 @@ intel_display_capture_error_state(struct drm_device *dev)
 	for (i = 0; i < error->num_transcoders; i++) {
 		enum transcoder cpu_transcoder = transcoders[i];
 
+		if (!intel_display_power_enabled(dev,
+				POWER_DOMAIN_TRANSCODER(cpu_transcoder)))
+			continue;
+
 		error->transcoder[i].cpu_transcoder = cpu_transcoder;
 
 		error->transcoder[i].conf = I915_READ(PIPECONF(cpu_transcoder));
@@ -11190,12 +11197,6 @@ intel_display_capture_error_state(struct drm_device *dev)
 		error->transcoder[i].vsync = I915_READ(VSYNC(cpu_transcoder));
 	}
 
-	/* In the code above we read the registers without checking if the power
-	 * well was on, so here we have to clear the FPGA_DBG_RM_NOCLAIM bit to
-	 * prevent the next I915_WRITE from detecting it and printing an error
-	 * message. */
-	intel_uncore_clear_errors(dev);
-
 	return error;
 }
 
-- 
1.8.3.1