[RFC v5 1/9] drivers/mfd: Add lookup table for Panel Control as GPIO signal

[Shobhit Kumar <shobhit.kumar@intel.com>]

On some Intel SoC platforms, the panel enable/disable signals are
controlled by CRC PMIC. Add those control as a new GPIO in a lookup
table for gpio-crystalcove chip during CRC driver load

CC: Samuel Ortiz <sameo@linux.intel.com>
Cc: Linus Walleij <linus.walleij@linaro.org>
Cc: Alexandre Courbot <gnurou@gmail.com>
Cc: Thierry Reding <thierry.reding@gmail.com>
Signed-off-by: Shobhit Kumar <shobhit.kumar@intel.com>
---
 drivers/mfd/intel_soc_pmic_core.c | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/drivers/mfd/intel_soc_pmic_core.c b/drivers/mfd/intel_soc_pmic_core.c
index 80cef04..365d5de 100644
--- a/drivers/mfd/intel_soc_pmic_core.c
+++ b/drivers/mfd/intel_soc_pmic_core.c
@@ -24,8 +24,19 @@
 #include <linux/acpi.h>
 #include <linux/regmap.h>
 #include <linux/mfd/intel_soc_pmic.h>
+#include <linux/gpio/machine.h>
 #include "intel_soc_pmic_core.h"
 
+/* Lookup table for the Panel Enable/Disable line as GPIO signals */
+struct gpiod_lookup_table panel_gpio_table = {
+	/* Intel GFX is consumer */
+	.dev_id = "0000:00:02.0",
+	.table = {
+		/* Panel EN/DISABLE */
+		GPIO_LOOKUP("gpio_crystalcove", 94, "panel", GPIO_ACTIVE_HIGH),
+	},
+};
+
 /*
  * On some boards the PMIC interrupt may come from a GPIO line.
  * Try to lookup the ACPI table and see if such connection exists. If not,
@@ -85,6 +96,9 @@ static int intel_soc_pmic_i2c_probe(struct i2c_client *i2c,
 	if (ret)
 		dev_warn(dev, "Can't enable IRQ as wake source: %d\n", ret);
 
+	/* Add lookup table binding for Panel Control to the GPIO Chip */
+	gpiod_add_lookup_table(&panel_gpio_table);
+
 	ret = mfd_add_devices(dev, -1, config->cell_dev,
 			      config->n_cell_devs, NULL, 0,
 			      regmap_irq_get_domain(pmic->irq_chip_data));
-- 
2.1.0

_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/intel-gfx