From: Joonas Lahtinen <joonas.lahtinen@linux.intel.com>
To: Imre Deak <imre.deak@intel.com>, intel-gfx@lists.freedesktop.org
Subject: Re: [PATCH 01/10] drm/i915: clarify comment about mandatory RPM put/get during driver load/unload
Date: Wed, 16 Dec 2015 12:44:27 +0200 [thread overview]
Message-ID: <1450262667.4707.9.camel@linux.intel.com> (raw)
In-Reply-To: <1450203038-5150-2-git-send-email-imre.deak@intel.com>
Hi,
On ti, 2015-12-15 at 20:10 +0200, Imre Deak wrote:
> Signed-off-by: Imre Deak <imre.deak@intel.com>
Reviewed-by: Joonas Lahtinen <joonas.lahtinen@linux.intel.com>
> ---
> drivers/gpu/drm/i915/intel_runtime_pm.c | 15 +++++++++++++--
> 1 file changed, 13 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/gpu/drm/i915/intel_runtime_pm.c
> b/drivers/gpu/drm/i915/intel_runtime_pm.c
> index 2c2151f..9945040 100644
> --- a/drivers/gpu/drm/i915/intel_runtime_pm.c
> +++ b/drivers/gpu/drm/i915/intel_runtime_pm.c
> @@ -1975,9 +1975,15 @@ int intel_power_domains_init(struct
> drm_i915_private *dev_priv)
> */
> void intel_power_domains_fini(struct drm_i915_private *dev_priv)
> {
> - /* The i915.ko module is still not prepared to be loaded
> when
> + /*
> + * The i915.ko module is still not prepared to be loaded
> when
> * the power well is not enabled, so just enable it in case
> - * we're going to unload/reload. */
> + * we're going to unload/reload.
+ * The following also reacquires the RPM reference the core
> passed
> + * to the driver during loading, which is dropped in
> + * intel_runtime_pm_enable(). We have to hand back the
> control of the
> + * device to the core with this reference held.
> + */
> intel_display_set_init_power(dev_priv, true);
>
> /* Remove the refcount we took to keep power well support
> disabled. */
> @@ -2313,6 +2319,11 @@ void intel_runtime_pm_enable(struct
> drm_i915_private *dev_priv)
> pm_runtime_mark_last_busy(device);
> pm_runtime_use_autosuspend(device);
>
> + /*
> + * The core calls the driver load handler with an RPM
> reference held.
> + * We drop that here and will reacquire it during unloading
> in
> + * intel_power_domains_fini().
> + */
> pm_runtime_put_autosuspend(device);
> }
>
--
Joonas Lahtinen
Open Source Technology Center
Intel Corporation
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/intel-gfx
next prev parent reply other threads:[~2015-12-16 10:44 UTC|newest]
Thread overview: 44+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-12-15 18:10 [PATCH v4 00/10] drm/i915: improve the RPM device suspended assert Imre Deak
2015-12-15 18:10 ` [PATCH 01/10] drm/i915: clarify comment about mandatory RPM put/get during driver load/unload Imre Deak
2015-12-16 10:44 ` Joonas Lahtinen [this message]
2015-12-15 18:10 ` [PATCH 02/10] drm/i915: disable power well support on platforms without runtime PM support Imre Deak
2015-12-15 20:57 ` Ville Syrjälä
2015-12-15 22:55 ` Imre Deak
2015-12-16 11:12 ` Daniel Vetter
2015-12-16 13:21 ` Imre Deak
2015-12-16 17:31 ` Ville Syrjälä
2015-12-16 18:13 ` Imre Deak
2015-12-15 18:10 ` [PATCH 03/10] drm/i915: refactor RPM disabling due to RC6 being disabled Imre Deak
2015-12-16 10:54 ` Joonas Lahtinen
2015-12-16 11:01 ` Joonas Lahtinen
2015-12-15 18:10 ` [PATCH 04/10] drm/i915: remove HAS_RUNTIME_PM check from RPM get/put/assert helpers Imre Deak
2015-12-16 10:56 ` Joonas Lahtinen
2015-12-16 13:49 ` [PATCH 4.1/10] drm/i915: get a permanent RPM reference on platforms w/o RPM support Imre Deak
2015-12-16 13:53 ` [PATCH v2 " Imre Deak
2015-12-16 17:26 ` Ville Syrjälä
2015-12-16 18:22 ` Imre Deak
2015-12-17 11:44 ` [PATCH v3.1/10] " Imre Deak
2015-12-17 11:48 ` [PATCH v5 04/10] drm/i915: remove HAS_RUNTIME_PM check from RPM get/put/assert helpers Imre Deak
2015-12-17 12:46 ` Joonas Lahtinen
2015-12-15 18:10 ` [PATCH 05/10] drm/i915: add assert_rpm_wakelock_held helper Imre Deak
2015-12-16 12:11 ` Chris Wilson
2015-12-16 12:54 ` Imre Deak
2015-12-16 13:02 ` Chris Wilson
2015-12-16 13:39 ` Joonas Lahtinen
2015-12-16 13:43 ` Imre Deak
2015-12-15 18:10 ` [PATCH 06/10] drm/i915: use assert_rpm_wakelock_held instead of opencoding it Imre Deak
2015-12-15 18:10 ` [PATCH 07/10] drm/i915: add support for checking if we hold an RPM reference Imre Deak
2015-12-15 21:07 ` Chris Wilson
2015-12-15 22:52 ` Imre Deak
2015-12-16 0:14 ` Chris Wilson
2015-12-16 0:52 ` [PATCH v5 " Imre Deak
2015-12-15 18:10 ` [PATCH 08/10] drm/i915: check that we hold an RPM wakelock ref before we put it Imre Deak
2015-12-16 11:00 ` Joonas Lahtinen
2015-12-16 11:07 ` Chris Wilson
2015-12-16 12:49 ` Imre Deak
2015-12-15 18:10 ` [PATCH 09/10] drm/i915: add support for checking RPM atomic sections Imre Deak
2015-12-16 11:06 ` Joonas Lahtinen
2015-12-16 11:18 ` Daniel Vetter
2015-12-16 22:53 ` Imre Deak
2015-12-15 18:10 ` [PATCH 10/10] drm/i915: check that we are in an RPM atomic section in GGTT PTE updaters Imre Deak
2015-12-17 14:44 ` [PATCH v4 00/10] drm/i915: improve the RPM device suspended assert Imre Deak
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1450262667.4707.9.camel@linux.intel.com \
--to=joonas.lahtinen@linux.intel.com \
--cc=imre.deak@intel.com \
--cc=intel-gfx@lists.freedesktop.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).