From: Marcin Szycik <marcin.szycik@linux.intel.com>
To: netdev@vger.kernel.org
Cc: simon.horman@corigine.com, kurt@linutronix.de, paulb@nvidia.com,
edumazet@google.com, boris.sukholitko@broadcom.com,
jiri@resnulli.us, paulus@samba.org, gnault@redhat.com,
jesse.brandeburg@intel.com, intel-wired-lan@lists.osuosl.org,
kuba@kernel.org, zhangkaiheb@126.com, pablo@netfilter.org,
baowen.zheng@corigine.com, komachi.yoshiki@gmail.com,
jhs@mojatatu.com, mostrows@earthlink.net,
xiyou.wangcong@gmail.com, pabeni@redhat.com,
gustavoars@kernel.org, davem@davemloft.net
Subject: [Intel-wired-lan] [RFC PATCH net-next v4 1/4] flow_dissector: Add PPPoE dissectors
Date: Fri, 8 Jul 2022 14:24:18 +0200 [thread overview]
Message-ID: <20220708122421.19309-2-marcin.szycik@linux.intel.com> (raw)
In-Reply-To: <20220708122421.19309-1-marcin.szycik@linux.intel.com>
From: Wojciech Drewek <wojciech.drewek@intel.com>
Allow to dissect PPPoE specific fields which are:
- session ID (16 bits)
- ppp protocol (16 bits)
- type (16 bits) - this is PPPoE ethertype, for now only
ETH_P_PPP_SES is supported, possible ETH_P_PPP_DISC
in the future
The goal is to make the following TC command possible:
# tc filter add dev ens6f0 ingress prio 1 protocol ppp_ses \
flower \
pppoe_sid 12 \
ppp_proto ip \
action drop
Note that only PPPoE Session is supported.
Signed-off-by: Wojciech Drewek <wojciech.drewek@intel.com>
---
v4:
* pppoe header validation
* added MPLS dissection
* added support for compressed ppp protocol field
* flow_dissector_key_pppoe::session_id stored in __be16
* new field: flow_dissector_key_pppoe::type
v3: revert byte order changes in is_ppp_proto_supported from
previous version
v2: ntohs instead of htons in is_ppp_proto_supported
include/net/flow_dissector.h | 13 ++++++
net/core/flow_dissector.c | 84 +++++++++++++++++++++++++++++++++---
2 files changed, 90 insertions(+), 7 deletions(-)
diff --git a/include/net/flow_dissector.h b/include/net/flow_dissector.h
index a4c6057c7097..af0d429b9a26 100644
--- a/include/net/flow_dissector.h
+++ b/include/net/flow_dissector.h
@@ -261,6 +261,18 @@ struct flow_dissector_key_num_of_vlans {
u8 num_of_vlans;
};
+/**
+ * struct flow_dissector_key_pppoe:
+ * @session_id: pppoe session id
+ * @ppp_proto: ppp protocol
+ * @type: pppoe eth type
+ */
+struct flow_dissector_key_pppoe {
+ __be16 session_id;
+ __be16 ppp_proto;
+ __be16 type;
+};
+
enum flow_dissector_key_id {
FLOW_DISSECTOR_KEY_CONTROL, /* struct flow_dissector_key_control */
FLOW_DISSECTOR_KEY_BASIC, /* struct flow_dissector_key_basic */
@@ -291,6 +303,7 @@ enum flow_dissector_key_id {
FLOW_DISSECTOR_KEY_CT, /* struct flow_dissector_key_ct */
FLOW_DISSECTOR_KEY_HASH, /* struct flow_dissector_key_hash */
FLOW_DISSECTOR_KEY_NUM_OF_VLANS, /* struct flow_dissector_key_num_of_vlans */
+ FLOW_DISSECTOR_KEY_PPPOE, /* struct flow_dissector_key_pppoe */
FLOW_DISSECTOR_KEY_MAX,
};
diff --git a/net/core/flow_dissector.c b/net/core/flow_dissector.c
index 6aee04f75e3e..3a90219d2354 100644
--- a/net/core/flow_dissector.c
+++ b/net/core/flow_dissector.c
@@ -895,6 +895,42 @@ bool bpf_flow_dissect(struct bpf_prog *prog, struct bpf_flow_dissector *ctx,
return result == BPF_OK;
}
+/**
+ * is_ppp_proto_supported - checks if inner PPP protocol should be dissected
+ * @proto: protocol type (PPP proto field)
+ */
+static bool is_ppp_proto_supported(__be16 proto)
+{
+ switch (proto) {
+ case htons(PPP_AT):
+ case htons(PPP_IPX):
+ case htons(PPP_VJC_COMP):
+ case htons(PPP_VJC_UNCOMP):
+ case htons(PPP_MP):
+ case htons(PPP_COMPFRAG):
+ case htons(PPP_COMP):
+ case htons(PPP_IPCP):
+ case htons(PPP_ATCP):
+ case htons(PPP_IPXCP):
+ case htons(PPP_IPV6CP):
+ case htons(PPP_CCPFRAG):
+ case htons(PPP_MPLSCP):
+ case htons(PPP_LCP):
+ case htons(PPP_PAP):
+ case htons(PPP_LQR):
+ case htons(PPP_CHAP):
+ case htons(PPP_CBCP):
+ return true;
+ default:
+ return false;
+ }
+}
+
+static bool is_pppoe_ses_hdr_valid(struct pppoe_hdr hdr)
+{
+ return hdr.ver == 1 && hdr.type == 1 && hdr.code == 0;
+}
+
/**
* __skb_flow_dissect - extract the flow_keys struct and return it
* @net: associated network namespace, derived from @skb if NULL
@@ -1214,26 +1250,60 @@ bool __skb_flow_dissect(const struct net *net,
struct pppoe_hdr hdr;
__be16 proto;
} *hdr, _hdr;
+ __be16 ppp_proto;
+
hdr = __skb_header_pointer(skb, nhoff, sizeof(_hdr), data, hlen, &_hdr);
if (!hdr) {
fdret = FLOW_DISSECT_RET_OUT_BAD;
break;
}
- nhoff += PPPOE_SES_HLEN;
- switch (hdr->proto) {
- case htons(PPP_IP):
+ if (!is_pppoe_ses_hdr_valid(hdr->hdr)) {
+ fdret = FLOW_DISSECT_RET_OUT_BAD;
+ break;
+ }
+
+ /* least significant bit of the first byte
+ * indicates if protocol field was compressed
+ */
+ if (hdr->proto & 1) {
+ ppp_proto = hdr->proto << 8;
+ nhoff += PPPOE_SES_HLEN - 1;
+ } else {
+ ppp_proto = hdr->proto;
+ nhoff += PPPOE_SES_HLEN;
+ }
+
+ if (ppp_proto == htons(PPP_IP)) {
proto = htons(ETH_P_IP);
fdret = FLOW_DISSECT_RET_PROTO_AGAIN;
- break;
- case htons(PPP_IPV6):
+ } else if (ppp_proto == htons(PPP_IPV6)) {
proto = htons(ETH_P_IPV6);
fdret = FLOW_DISSECT_RET_PROTO_AGAIN;
- break;
- default:
+ } else if (ppp_proto == htons(PPP_MPLS_UC)) {
+ proto = htons(ETH_P_MPLS_UC);
+ fdret = FLOW_DISSECT_RET_PROTO_AGAIN;
+ } else if (ppp_proto == htons(PPP_MPLS_MC)) {
+ proto = htons(ETH_P_MPLS_MC);
+ fdret = FLOW_DISSECT_RET_PROTO_AGAIN;
+ } else if (is_ppp_proto_supported(ppp_proto)) {
+ fdret = FLOW_DISSECT_RET_OUT_GOOD;
+ } else {
fdret = FLOW_DISSECT_RET_OUT_BAD;
break;
}
+
+ if (dissector_uses_key(flow_dissector,
+ FLOW_DISSECTOR_KEY_PPPOE)) {
+ struct flow_dissector_key_pppoe *key_pppoe;
+
+ key_pppoe = skb_flow_dissector_target(flow_dissector,
+ FLOW_DISSECTOR_KEY_PPPOE,
+ target_container);
+ key_pppoe->session_id = hdr->hdr.sid;
+ key_pppoe->ppp_proto = ppp_proto;
+ key_pppoe->type = htons(ETH_P_PPP_SES);
+ }
break;
}
case htons(ETH_P_TIPC): {
--
2.35.1
_______________________________________________
Intel-wired-lan mailing list
Intel-wired-lan@osuosl.org
https://lists.osuosl.org/mailman/listinfo/intel-wired-lan
next prev parent reply other threads:[~2022-07-08 12:25 UTC|newest]
Thread overview: 14+ messages / expand[flat|nested] mbox.gz Atom feed top
2022-07-08 12:24 [Intel-wired-lan] [RFC PATCH net-next v4 0/4] ice: PPPoE offload support Marcin Szycik
2022-07-08 12:24 ` Marcin Szycik [this message]
2022-07-08 19:05 ` [Intel-wired-lan] [RFC PATCH net-next v4 1/4] flow_dissector: Add PPPoE dissectors Guillaume Nault
2022-07-11 10:23 ` Drewek, Wojciech
2022-07-12 17:20 ` Guillaume Nault
2022-07-13 7:58 ` Drewek, Wojciech
2022-07-13 13:54 ` Drewek, Wojciech
2022-07-17 11:15 ` Guillaume Nault
2022-07-08 12:24 ` [Intel-wired-lan] [RFC PATCH net-next v4 2/4] net/sched: flower: Add PPPoE filter Marcin Szycik
2022-07-08 19:22 ` Guillaume Nault
2022-07-11 10:26 ` Drewek, Wojciech
2022-07-12 17:31 ` Guillaume Nault
2022-07-08 12:24 ` [Intel-wired-lan] [RFC PATCH net-next v4 3/4] flow_offload: Introduce flow_match_pppoe Marcin Szycik
2022-07-08 12:24 ` [Intel-wired-lan] [RFC PATCH net-next v4 4/4] ice: Add support for PPPoE hardware offload Marcin Szycik
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20220708122421.19309-2-marcin.szycik@linux.intel.com \
--to=marcin.szycik@linux.intel.com \
--cc=baowen.zheng@corigine.com \
--cc=boris.sukholitko@broadcom.com \
--cc=davem@davemloft.net \
--cc=edumazet@google.com \
--cc=gnault@redhat.com \
--cc=gustavoars@kernel.org \
--cc=intel-wired-lan@lists.osuosl.org \
--cc=jesse.brandeburg@intel.com \
--cc=jhs@mojatatu.com \
--cc=jiri@resnulli.us \
--cc=komachi.yoshiki@gmail.com \
--cc=kuba@kernel.org \
--cc=kurt@linutronix.de \
--cc=mostrows@earthlink.net \
--cc=netdev@vger.kernel.org \
--cc=pabeni@redhat.com \
--cc=pablo@netfilter.org \
--cc=paulb@nvidia.com \
--cc=paulus@samba.org \
--cc=simon.horman@corigine.com \
--cc=xiyou.wangcong@gmail.com \
--cc=zhangkaiheb@126.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox