[PATCH 04/10] drm/xe: Move HWSTAM programming to RTP

[Matt Roper <matthew.d.roper@intel.com>]

The write to RING_HWSTAM to disable hardware status page writes on
interrupt was unnecessarily open-coded in xe_hw_engine_enable_ring();
it's preferable to do such programming in the engine_entries[] RTP table
since gets reflected/verified in debugfs, and will also automatically
ensure that the register is properly saved/restored around engine
resets.

In this case the HWSTAM register wasn't explicitly added to the GuC ADS'
save-restore list, so there was the potential for the value to be lost
on engine resets.  This doesn't seem to have happened in practice, so
likely the GuC firmware is automatically saving/restoring this register
on our behalf, but we shouldn't rely on this implicit behavior going
forward.

One other slight change with this patch is that HWSTAM will now be
programmed on the vestigial execlist (non-GuC) initialization path.
Since the register's default value is 0x0 and the documentation
indicates that it's only legal to leave a single bit unmasked at a time,
this likely would have been an illegal situation if the execlist code
were actually usable.

Signed-off-by: Matt Roper <matthew.d.roper@intel.com>
---
 drivers/gpu/drm/xe/xe_hw_engine.c | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/drivers/gpu/drm/xe/xe_hw_engine.c b/drivers/gpu/drm/xe/xe_hw_engine.c
index 62a47d7e3f02..06eb655a4ae5 100644
--- a/drivers/gpu/drm/xe/xe_hw_engine.c
+++ b/drivers/gpu/drm/xe/xe_hw_engine.c
@@ -327,7 +327,6 @@ void xe_hw_engine_enable_ring(struct xe_hw_engine *hwe)
 {
 	u32 ring_mode = REG_MASKED_FIELD_ENABLE(GFX_DISABLE_LEGACY_MODE);
 
-	xe_hw_engine_mmio_write32(hwe, RING_HWSTAM(0), ~0x0);
 	xe_hw_engine_mmio_write32(hwe, RING_HWS_PGA(0),
 				  xe_bo_ggtt_addr(hwe->hwsp));
 
@@ -437,6 +436,11 @@ hw_engine_setup_default_state(struct xe_hw_engine *hwe)
 					   ring_cmd_cctl_val,
 					   XE_RTP_ACTION_FLAG(ENGINE_BASE)))
 		},
+		{ XE_RTP_NAME("Disable HW status page updates for interrupts"),
+		  XE_RTP_RULES(FUNC(xe_rtp_match_always)),
+		  XE_RTP_ACTIONS(SET(RING_HWSTAM(0), ~0x0,
+				     XE_RTP_ACTION_FLAG(ENGINE_BASE)))
+		},
 		/*
 		 * To allow the GSC engine to go idle on MTL we need to enable
 		 * idle messaging and set the hysteresis value (we use 0xA=5us

-- 
2.53.0