[RFC v1 8/8] crash hp: Add x86 crash hotplug support for bzImage

[Eric DeVolder <eric.devolder@oracle.com>]

The few changes to kexec-bzimage64.c are to record information needed
in advance of when a hotplug event occurs. This information is recorded
when the crash/capture kernel is loaded.

In particular, the index of the purgatory segment, and the handful of
register context values needed by purgatory, are recorded.

Signed-off-by: Eric DeVolder <eric.devolder@oracle.com>
---
 arch/x86/kernel/kexec-bzimage64.c | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/arch/x86/kernel/kexec-bzimage64.c b/arch/x86/kernel/kexec-bzimage64.c
index 170d0fd68b1f..1886c215215d 100644
--- a/arch/x86/kernel/kexec-bzimage64.c
+++ b/arch/x86/kernel/kexec-bzimage64.c
@@ -378,6 +378,10 @@ static void *bzImage64_load(struct kimage *image, char *kernel,
 	 * Load purgatory. For 64bit entry point, purgatory  code can be
 	 * anywhere.
 	 */
+#ifdef CONFIG_CRASH_HOTPLUG
+	/* Record the index of the purgatory segment */
+	image->arch.hp.purg_index = image->nr_segments;
+#endif
 	ret = kexec_load_purgatory(image, &pbuf);
 	if (ret) {
 		pr_err("Loading purgatory failed\n");
@@ -488,6 +492,14 @@ static void *bzImage64_load(struct kimage *image, char *kernel,
 	if (ret)
 		goto out_free_params;
 
+#ifdef CONFIG_CRASH_HOTPLUG
+	/* Save for use on hotplug to patch up purgatory context */
+	image->arch.hp.rbx = regs64.rbx;
+	image->arch.hp.rsi = regs64.rsi;
+	image->arch.hp.rip = regs64.rip;
+	image->arch.hp.rsp = regs64.rsp;
+#endif
+
 	ret = setup_boot_parameters(image, params, bootparam_load_addr,
 				    efi_map_offset, efi_map_sz,
 				    efi_setup_data_offset);
-- 
2.27.0


_______________________________________________
kexec mailing list
kexec@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/kexec