--- dmesg.f7_32bit_default 2007-08-09 16:00:00.000000000 -0700 +++ dmesg.f7_32bit_forced_acpi 2007-08-09 15:59:55.000000000 -0700 @@ -34,21 +34,30 @@ ACPI: FACS 1FFF00C0, 0040 ACPI: APIC 1FFF0938, 0040 (r1 QEMU QEMUAPIC 1 QEMU 1) ACPI: no DMI BIOS year, acpi=force is required to enable ACPI -ACPI: Disabling ACPI support +ACPI: acpi=force override +ACPI: PM-Timer IO Port: 0xb008 +ACPI: Local APIC address 0xfee00000 +ACPI: LAPIC (acpi_id[0x00] lapic_id[0x00] enabled) +Processor #0 6:2 APIC version 17 +ACPI: IOAPIC (id[0x01] address[0xfec00000] gsi_base[0]) +IOAPIC[0]: apic_id 1, version 17, address 0xfec00000, GSI 0-23 +ACPI: IRQ11 used by override. +Enabling APIC mode: Flat. Using 1 I/O APICs +Using ACPI (MADT) for SMP configuration information Allocating PCI resources starting at 30000000 (gap: 20000000:dffc0000) swsusp: Registered nosave memory region: 000000000009f000 - 00000000000a0000 swsusp: Registered nosave memory region: 00000000000a0000 - 00000000000e8000 swsusp: Registered nosave memory region: 00000000000e8000 - 0000000000100000 Built 1 zonelists in Zone order. Total pages: 129265 -Kernel command line: ro root=/dev/VolGroup00/LogVol00 console=tty0 console=ttyS0 debug -Found and enabled local APIC! +Kernel command line: ro root=/dev/VolGroup00/LogVol00 console=tty0 console=ttyS0 debug acpi=force mapped APIC to ffffb000 (fee00000) +mapped IOAPIC to ffffa000 (fec00000) Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Initializing CPU#0 CPU 0 irqstacks, hard=c0817000 soft=c07f7000 PID hash table entries: 2048 (order: 11, 8192 bytes) -Detected 2400.636 MHz processor. +Detected 2400.387 MHz processor. Console: colour VGA+ 80x25 console [tty0] enabled console [ttyS0] enabled @@ -75,7 +84,7 @@ .text : 0xc0400000 - 0xc063074d (2241 kB) Checking if this processor honours the WP bit even in supervisor mode... Ok. SLUB: Genslabs=22, HWalign=64, Order=0-1, MinObjects=4, CPUs=1, Nodes=1 -Calibrating delay using timer specific routine.. 9619.97 BogoMIPS (lpj=4809986) +Calibrating delay using timer specific routine.. 9622.99 BogoMIPS (lpj=4811496) Security Framework v1.0.0 initialized SELinux: Initializing. SELinux: Starting in permissive mode @@ -92,8 +101,13 @@ Checking 'hlt' instruction... OK. SMP alternatives: switching to UP code Freeing SMP alternatives: 12k freed +ACPI: Core revision 20070126 CPU0: Intel QEMU Virtual CPU version 0.9.0 stepping 03 -SMP motherboard not detected. +Total of 1 processors activated (9622.99 BogoMIPS). +ENABLING IO-APIC IRQs +..TIMER: vector=0x31 apic1=0 pin1=0 apic2=-1 pin2=-1 +APIC calibration not consistent with PM Timer: 199ms instead of 100ms +APIC delta adjusted to PM-Timer: 6249985 (12499675) Brought up 1 CPUs sizeof(vma)=84 bytes sizeof(page)=56 bytes @@ -106,25 +120,36 @@ khelper used greatest stack depth: 3160 bytes left Booting paravirtualized kernel on bare hardware khelper used greatest stack depth: 3084 bytes left -Time: 22:48:42 Date: 07/09/107 +Time: 22:55:44 Date: 07/09/107 NET: Registered protocol family 16 +ACPI: bus type pci registered PCI: PCI BIOS revision 2.10 entry at 0xfa130, last bus=0 PCI: Using configuration type 1 Setting up standard PCI resources -khelper used greatest stack depth: 2928 bytes left -ACPI: Interpreter disabled. -Linux Plug and Play Support v0.97 (c) Adam Belay -pnp: PnP ACPI: disabled -usbcore: registered new interface driver usbfs -usbcore: registered new interface driver hub -usbcore: registered new device driver usb -PCI: Probing PCI hardware -PCI: Probing PCI hardware (bus 00) +ACPI: Interpreter enabled +ACPI: (supports) +ACPI: Using IOAPIC for interrupt routing +khelper used greatest stack depth: 2944 bytes left +ACPI: PCI Root Bridge [PCI0] (0000:00) * Found PM-Timer Bug on the chipset. Due to workarounds for a bug, * this clock source is slow. Consider trying other clock sources PCI quirk: region b000-b03f claimed by PIIX4 ACPI PCI quirk: region b100-b10f claimed by PIIX4 SMB -PCI: Using IRQ router PIIX/ICH [8086/7000] at 0000:00:01.0 +ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT] +ACPI: PCI Interrupt Link [LNKA] (IRQs 3 4 5 6 7 9 10 *11 12) +ACPI: PCI Interrupt Link [LNKB] (IRQs 3 4 5 6 7 *9 10 11 12) +ACPI: PCI Interrupt Link [LNKC] (IRQs 3 4 5 6 7 9 10 *11 12) +ACPI: PCI Interrupt Link [LNKD] (IRQs 3 4 5 6 7 *9 10 11 12) +Linux Plug and Play Support v0.97 (c) Adam Belay +pnp: PnP ACPI init +ACPI: bus type pnp registered +pnp: PnP ACPI: found 6 devices +ACPI: ACPI bus type pnp unregistered +usbcore: registered new interface driver usbfs +usbcore: registered new interface driver hub +usbcore: registered new device driver usb +PCI: Using ACPI for IRQ routing +PCI: If a device doesn't work, try "pci=routeirq". If it helps, post a report NetLabel: Initializing NetLabel: domain hash size = 128 NetLabel: protocols = UNLABELED CIPSOv4 @@ -139,10 +164,10 @@ checking if image is initramfs... it is Freeing initrd memory: 3801k freed apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16ac) +apm: overridden by ACPI. audit: initializing netlink socket (disabled) -audit(1186699721.596:1): initialized +audit(1186700143.557:1): initialized Total HugeTLB memory allocated, 0 -khelper used greatest stack depth: 2888 bytes left VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) SELinux: Registering netfilter hooks @@ -159,17 +184,19 @@ Activating ISA DMA hang workarounds. Boot video device is 0000:00:02.0 pci_hotplug: PCI Hot Plug PCI Core version: 0.5 -khelper used greatest stack depth: 2860 bytes left isapnp: Scanning for PnP cards... +Switched to high resolution mode on CPU 0 isapnp: No Plug & Play device found Generic RTC Driver v1.07 Non-volatile memory driver v1.2 Linux agpgart interface v0.102 Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16450 +00:05: ttyS0 at I/O 0x3f8 (irq = 4) is a 16450 RAMDISK driver initialized: 16 RAM disks of 16384K size 4096 blocksize +khelper used greatest stack depth: 2784 bytes left input: Macintosh mouse button emulation as /class/input/input0 -PNP: No PS/2 controller found. Probing ports directly. +PNP: PS/2 Controller [PNP0303:KBD,PNP0f13:MOU] at 0x60,0x64 irq 1,12 serio: i8042 KBD port at 0x60,0x64 irq 1 serio: i8042 AUX port at 0x60,0x64 irq 12 mice: PS/2 mouse device common for all mice @@ -182,17 +209,15 @@ NET: Registered protocol family 1 NET: Registered protocol family 17 Using IPI No-Shortcut mode - Magic number: 3:809:855 + Magic number: 3:912:956 drivers/rtc/hctosys.c: unable to open rtc device (rtc0) Freeing unused kernel memory: 568k freed Write protecting the kernel read-only data: 916k -Clocksource tsc unstable (delta = 542506452 ns) -Time: pit clocksource has been installed. +input: ImExPS/2 Generic Explorer Mouse as /class/input/input2 USB Universal Host Controller Interface driver v3.0 -insmod used greatest stack depth: 2492 bytes left +insmod used greatest stack depth: 2340 bytes left ohci_hcd: 2006 August 04 USB 1.1 'Open' Host Controller (OHCI) Driver -insmod used greatest stack depth: 2400 bytes left -input: ImExPS/2 Generic Explorer Mouse as /class/input/input2 +insmod used greatest stack depth: 2312 bytes left SCSI subsystem initialized libata version 2.21 loaded. ata_piix 0000:00:01.1: version 2.11 @@ -220,28 +245,25 @@ scsi 1:0:0:0: CD-ROM QEMU QEMU CD-ROM 0.9. PQ: 0 ANSI: 5 insmod used greatest stack depth: 876 bytes left device-mapper: ioctl: 4.11.0-ioctl (2006-10-12) initialised: dm-devel-H+wXaHxf7aLQT0dZR+AlfA@public.gmane.org -EXT3-fs: INFO: recovery required on readonly filesystem. -EXT3-fs: write access will be enabled during recovery. kjournald starting. Commit interval 5 seconds -EXT3-fs: dm-0: orphan cleanup on readonly fs -ext3_orphan_cleanup: deleting unreferenced inode 2254377 -EXT3-fs: dm-0: 1 orphan inode deleted -EXT3-fs: recovery complete. EXT3-fs: mounted filesystem with ordered data mode. SELinux: Disabled at runtime. SELinux: Unregistering netfilter hooks -audit(1186699726.899:2): selinux=0 auid=4294967295 +audit(1186700148.939:2): selinux=0 auid=4294967295 sd 0:0:0:0: Attached scsi generic sg0 type 0 scsi 1:0:0:0: Attached scsi generic sg1 type 5 sr0: scsi3-mmc drive: 4x/4x xa/form2 tray Uniform CD-ROM driver Revision: 3.20 sr 1:0:0:0: Attached scsi CD-ROM sr0 -ne2k-pci.c:v1.03 9/22/2003 D. Becker/P. Gortmaker -PCI: setting IRQ 11 as level-triggered -PCI: Found IRQ 11 for device 0000:00:03.0 -eth0: RealTek RTL-8029 found at 0xc100, IRQ 11, 52:54:00:12:34:56. piix4_smbus 0000:00:01.3: Found 0000:00:01.3 device +ne2k-pci.c:v1.03 9/22/2003 D. Becker/P. Gortmaker +ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 10 +ACPI: PCI Interrupt 0000:00:03.0[A] -> Link [LNKC] -> GSI 10 (level, low) -> IRQ 10 +eth0: RealTek RTL-8029 found at 0xc100, IRQ 10, 52:54:00:12:34:56. +parport_pc 00:04: reported by Plug and Play ACPI +parport0: PC-style at 0x378, irq 7 [PCSPP,EPP] FDC 0 is a S82078B +No dock devices found. device-mapper: multipath: version 1.0.5 loaded EXT3 FS on dm-0, internal journal kjournald starting. Commit interval 5 seconds